Instruction manual
15
G-Series SP20004_REV_2
*HQHUDO/XEULFDWLRQ
5($552//(5
PRQWKV
The main drive roller is split into three sections incorporating a differential gear system running in an oil bath. The old oil
should be drained off and the bath replenished with 1 pint (550ml) of clean oil.
PRQWK
A grease point is located under the belt guard on the side plate of the machine. This is to lubricate the internal spur gear
that provides drive to the rear roller. Apply one pump of grease. Do not over grease.
&21752//(9(56$1'&$%/(6
PRQWKV
Apply a small amount of oil to the control cables. Flow down the protective cables can be assisted by operating the lever
a few times after lubricating.
)521752//(5$'-867(56
PRQWKV
Apply a small quantity of copper grease or similar to the adjuster studs to prevent corrosion and ease adjustment.