Instruction manual

5
G-Series SP20004_REV_2
0DFKLQH'HVFULSWLRQ
Manufactured with a 26” (66cm), 30” (76cm) or 34” (86cm) cutting width, this range of machines is powered by either a
5.5hp (26” & 30”) or 6.5hp air cooled, single cylinder, four stroke petrol engine.
The rear roller and cutter are controlled independently via belt clutches operated from the console on the upper handle
bar. (ITEM 5). A parking brake is ¿tted for added safety when working on sloping ground.
In the design of the machine, special attention has been given to the importance of easy service and maintenance with
the construction based on a sectional assembly system. These are the Engine Unit, the Cassette Unit, the Rear Roller
Unit, and the Front Roller Unit, each of which can be readily removed individually from the main Frame Chassis Unit.
The interchangeable cassette system allows a variety of cassettes to be used for varying applications.
1. Cassette 9. Grassbox
2. Bottom Blade Adjuster Knob 10. Cutting Height Adjustment
3. Belt Guard 11. Cassette Retaining Pin
4. Throttle Control Lever 12. Cassette Control Lever
5. Operating Console 13. Air Filter
6. Exhaust 14. Driving Control Lever
7. Fuel Tank 15. Deadmans Handle
8. Brake Lever 16. On / Off Switch
1
2
3
8
4
5
6
7
2
9
15
10
11
12
13
14
16