Instruction manual
7
G-Series SP20004_REV_2
Controls
)257+(/2&$7,212)&21752/6$1'&20321(1765()³0$&+,1('(6&5,37,21´3$*(
212))6:,7&+,WHP
This switch stops the engine and can be used to do so at anytime during the operation of the machine. Ensure it is in the ³21´
position before attempting to start the engine.
'($'0$16&21752/,WHP
This is an operator presence control. The engine will tick over without need for this to be depressed when the cylinder and
drive are disengaged. This must be depressed before the drive or cylinder can be engaged. Failure to do so will cause the
engine to stop.
7+5277/(&21752/,WHP
This controls the RPM of the engine and the resultant speed of the machine. Pushing the lever forwards will increase the RPM,
pulling it back returns the engine to idle.
'5,9(&2172/,WHP
This controls the machine movement. Pushing the lever forwards will engage the belt clutch and cause the machine to drive.
Returning it to the original position will cause the machine to stop.
&</,1'(5&21752/,WHP
This controls the cylinder drive. Pushing the lever forwards will engage the belt clutch and cause the cylinder to rotate. Return-
ing it to the original position will cause the cylinder to stop.
IF THE “DEADMANS CONTROL LEVER” IS DEPRESSED WHILE THE PARKING BRAKE IS
ON THE ENGINE WILL STOP.
NOTE
IF THE “DEADMANS CONTROL LEVER” IS DEPRESSED WHILE THE PARKING BRAKE IS
ON THE ENGINE WILL STOP.
NOTE
3$5.,1*%5$.(&21752/,WHP
This controls the parking brake. It is only to be engaged when the machine is stationary, it is NOT to stop the machine. Push
lever forwards to engage and pull back to disengage.