User Manual

13
Before use
Part names and
functions
Connections
Basic
operations
Installing and setting up
supplied software
Troubleshooting Index
Specifications
Signal system chart
USB settings
MIDI command input/output
ThisunitisequippedwithaUSBMIDIcommandinput/outputfunction.ThisfunctionenablestheunittocontroltheDJsoftwareinthecomputer,andlightsthemainunitdisplay(LEDs).
•If SERATO DJ INTRO is used normally, there is no need to switch MIDI command settings or the MIDI channel. Doing so may cause undesired operation or no operation at all.
OtherDJsoftwarecanbecustomizedtomatchtheMIDIcommandsofthisdevice,andcanthenbecontrolledbythisdevice.
Most of the controls in this device support the MIDI control function.
SHIFT
BROWSE1
SEL.
BROWSE2
Top panel
The following buttons and switches do not support MIDI output.
•MIC LEVEL
•AUX IN LEVEL
•AUX IN MONITOR LEVEL
Setting the MIDI command transmission interval time
Depending on the computer specifications and OS type, the computer may not be able to receive the MIDI
commands transmitted from this unit correctly.
In this case, use the following operation to set the MIDI command transmission interval time to a suitable
value.
1
Hold down BROWSE 1, BROWSE 2 and SHIFT together while plugging in the
USB cable.
After the start up display has completed, the device switches to the setting mode for the MIDI
command transmission interval time.
2
Turn SEL.
Specifications are as shown below.
LEFT DECK
HOT
CUE1
HOT
CUE2
HOT
CUE3
HOT
CUE4
LOOP
IN
LOOP
OUT
AUTO FX1-1 FX1-2 FX1-3
Interval time
[ms]
- - 3 4 5 6 7 8 9 10
RIGHT DECK
HOT
CUE1
HOT
CUE2
HOT
CUE3
HOT
CUE4
LOOP
IN
LOOP
OUT
AUTO FX2-1 FX2-2 FX2-3
Interval time
[ms]
11 12 13 14 15 16 17 18 19 20
•The factory setting is 4 msec.
3
Press SEL.
The MIDI command transmission interval time is entered.
4
Press SHIFT.
The settings are completed, and unit exits the setting mode.