Owner's Manual
Table Of Contents
pursuant
to
Part 15
of
the FCC rules. These limits are designed
to
provide reasonab
le
protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and,
if
not
installed and used in accordance with the instructions,
may
cause harmful
interference to radio communications. However, there is no guarantee that interference will
not
occur in a
particular installation.
If
this equipment does cause harmful interference
to
radio
or
television reception,
which can be determined
by
turning the equipment
off
and on, the user is encouraged
to
try
to
correct the
interference by one
or
more
of
the following measures:
(a)
reorient
or
relocate the receiving antenna;
(b)
move this unit; (c) increase the separation between the equipment and receiver;
(d)
connect the equipment
into an outlet on a circuit different from that
to
which the receiver is connected;
(e)
be sure that all cables are
properly shielded, using a choke
or
ferrite where appropriate;
or
(
f)
consult the dealer
or
an experienced
radio/television technician for help.
This device complies with Part 15
of
the FCC rules. Operation is subject
to
the following
two
conditions: (
1)
this device may
not
cause harmful interference, and
(2)
this device must accept any interference received,
including interference that may cause undesired operation.
FCC Radiation Exposure Statement: This equipment complies with
FCC
radiation exposure limits set forth
for
an uncontrolled environment. This equipment should
be
installed and operated with a minimum distance
of
20 cm between the radiator and your body.
For Canadian models:
• This device complies with Industry Canada licence-exempt RSSs. Operation is subject
to
the following
two
conditions: (1) this device may
not
cause interference, and
(2)
this device must accept any
interference, including interference that may cause undesired operation
of
the device.
• Under Industry Canada regulations, this radio transmitter may only operate using
an
antenna
of
a type
and maximum (or lesser) gain approved for the transmitter
by
Industry Canada.
To
redu
ce
potential
radio interference
to
other users, the antenna type and its gain should
be
so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is
not
more than that necessary
for
successful communication.
• This radio transmitter (identify the device by certification number,
or
model number
if
Category
II)
has
been approved
by
Industry Canada
to
operate with the antenna types listed below with the maximum
permissible gain and required antenna impedance for each antenna type indicated. Antenna types not
included in this list, having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
• This unit does not exceed the Class B limits
for
radio noise emission from digital apparatus set out in
the radio interference regulations
of
the Canadian Department
of
Communications.
• This device operates on a no-protection, no-interference basis. Should the user seek
to
obtain
protection from other radio services operating
in
the same TV bands, a radio licence is required. For
further details, consult Innovation, Science and Economic Development Canada's document Client
Procedures Circular CPC-2-1-28, Voluntary Licensing
of
Licence-Exempt Low-Power Radio Apparatus
in the TV Bands.
12
Wireless Microphone (if applicable): This device complies with Part 15
of
the
FCC
Rules. Operation is
subject
to
the condition that this device does
not
cause harmful interference.
For
wireless
products
supporting
the
5G
frequency
band
(if applicable): Usage of
the
5.15--5.25 GHz
band are restricted
to
indoor operation only. This applies
to
the following countries: AT, BE, BG, CZ, DK,
EE,
FR,
DE,
IS,
IE, IT,
El,
ES,
CY, LV, LI,
LT,
LU
, HU, MT, NL, NO,
Pl
, PT,
RO,
SI, SK,
TR,
Fl, SE, CH, UK,
HR.
ESD/EFT Warning: This unit may contain a microcomputer
for
signal processing and control
functions. In very rare situations, severe interference, noise from an external source,
or
static
electricity may cause it
to
lock up. In the unlikely event that this should happen, turn
off
the unit,
wait at least five seconds, and then turn it back on again. The pins
of
connectors identified with
this
ESD
warning symbol should
not
be touched.
RF Warning Statement: The device has been evaluated
to
meet general
RF
exposure requirement. The
device can
be
used in portable exposure condition without restriction.
For best audio quality, avoid using this device in a high RF-radiated environment. In an environment with radio
frequency interference, the unit may malfunction and resume normal operation after removal
of
the interference.
For 240-volt use in U.K., use NEMA• -style 240-volt plug. For other countries use proper plug for local outlet.
Double-Insulated: When servicing use only identical replacement parts.
-
Correct Disposal
of
This Product: This marking indicates that this product should
not
be
disposed with other household wastes throughout the
EU.
To prevent possible harm to the
environment
or
human health from uncontrolled waste disposal, recycle it responsibly
to
promote the sustainable reuse
of
material resources. To return your used device, please use the
return and collection systems
or
contact the retailer where the product was purchased. They can
take this product
for
environmentally safe recycling.
If
apparatus
contains
a
coin/button-cell
battery:
Warning: Do not ingest the
battery-
chemical
burn
hazard. The remote control supplied with this product contains a coin/button-
cell battery. If the coin/button-cell battery is swallowed,
it
can cause severe internal burns in just
2 hours and can lead
to
death. Keep
new
and used batteries away from children. If the battery
compartment does
not
close securely, stop using the product and keep it away from children. If
you think batteries might have been swallow~d
or
placed inside any part
of
the body, seek
immediate medical attention.
13