Owner's Manual
Table Of Contents
12. Power Sources (if applicable): This
product
should be connected
to
a power supply only
of
the
type
described in these
operating instructions,
or
as marked on
the
unit.
13. Internal/External Voltage Selectors (if applicable): Internal or external voltage selector switches, if any, should only
be
reset and
re-equipped with a proper plug for alternative voltage
by
a qualified service technician. Do not attempt
to
alter this yourself.
14. Water and Moisture (if applicable): This product should be kept away from direct contact with liquids. The apparatus shall not
be
exposed
to
dripping or splashing and that no objects filled with liquids, such as vases, shall
be
placed on the apparatus.
15. Caution (if applicable): Danger
of
explosion if battery is incorrectly replaced. Replace only with the same
or
equivalent
type. Batteries
(a
battery pack
or
an installed battery) shall not be exposes
to
excessive heat such as sunshine, fire, etc.
16. (If applicable) Where the mains plug
or
an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable. @
17. Protective earthing terminal (if applicable): The apparatus should be connected
to
a mains socket outlet with a
-::!:-
protective earthing connection. -
• Denmark (Danmark): Apparatets stikprop skal tilsluttes en stikkontakt med jord, som giver forbindelse til stikproppens jord.
• Finland (Suom,): Laite on liitettava suojakoskettimilla varustettuun pistorasiaan.
• Norway (Norge): Apparatet
mA
tilkoples
jordet
stikkontakt.
• Sweden
(Sverige):
Apparaten skall anslutas till jordat uttag. [g]
18. For Class
II
apparatus
only:
This symbol means the equipment is a Class
II
or
double-insulated electrical appliance. D
It has been designed
in
such a way that it does not require a safety connection
to
electrical earth.
19. Class II Wiring (if applicable):
To
reduce the risk
of
electric shock, the external wiring connected
to
the terminals with
"Class
II
Wiring" requires Class
II
wiring installed
by
an instructed person
or
the use
of
ready-made leads
or
cords.
20. Warning (if applicable): Provide an earthing connection before
the
mains plug is connected
to
the
mains. When
disconnecting
the
earthing connection, be sure
to
disconnect it after pulling the mains plug
out
from
the
mains.
21. This apparatus is
for
professional use only. Intended operational climate: moderate.
22. (If applicable) When moving
or
not
using the appliance, secure the power cord (e.g.,
wrap
it with a cable tie). Be careful
not
to
damage
the
power cord. Before using it again, make sure the power cord has
not
been damaged. If
the
power cord
has been damaged
at
all, bring
the
unit and cord
to
a qualified service technician
for
repair
or
replacement as specified
by
the
manufacturer.
23. Warning (if applicable): Excessive sound pressure (high volumes) from headphones can cause hearing loss.
24. Warning (if applicable): Please refer
to
any important information (e.g., electrical, safety, etc.) printed on the exterior
bottom
enclosure
or
rear panel before installing
or
operating the product.
25. Warning (if applicable): Terminals marked with
the
lightning bolt symbol
may
be
of
sufficient magnitude
to
constitute £
a risk
of
electric shock. 1
Service Instructions
• Disconnect
power
cord before servicing.
• Replace critical components
Lh
only with factory parts
or
recommended equivalents.
• For AC line powered units: Before returning repaired unit
to
user, use an ohmmeter
to
measure from
both
AC
plug blades
to
all exposed metal parts. The resistance should
be
more than 2,000,000 ohms.
Safety Notices
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
~
. •
Lt
ANY COVER. NO USER- SERVICEABLE PARTS INSIDE. REFER SERVICING TO I Risk
of
electric shock.
QUALIFIED SERVICE PERSONNEL ONLY.
■
Do
not
open.
DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol within the equilateral triangle is intended
to
Ji>..
alert the user
to
the
presence
of
un-insulated "dangerous voltage" within the
product's
enclosure that
may
be
of
~
sufficient magnitude
to
constitute a risk
of
electric shock.
SA
1965
INSTRUCTIONS: The exclamation point within the equilateral triangle is intended
to
alert the user
to
the
presence
'I'
of
important operating and maintenance (servicing) instructions in the literature accompanying this appliance.
~
SA 1966
WARNING:
To
reduce
the
risk
of
fire
or
electrical shock,
do
not
expose this appliance
to
rain
or
moisture. Electrical equipment
should NEVER be kept
or
stored in
damp
environments.
CAUTION (for U.S.A. & CANADIAN models
only):
TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED) PLUG
WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO
PREVENT BLADE EXPOSURE.
NOTICE CONCERNING LASER PRODUCTS: DANGER: INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK
FAILED OR DEFEATED. AVOID DIRECT EXPOSURE TO BEAM. USE OF CONTROLS OR ADJUSTMENTS OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT
IN
HAZARDOUS RADIATION EXPOSURE.
NOTICE CONCERNING FCC REGULATIONS: You are cautioned that changes
or
modifications not expressly approved
by
the
part responsible
for
compliance could void the user's authority
to
operate
the
equipment. This equipment has been tested
and found
to
comply
with the limits for a Class B digital device, pursuant
to
Part
15
of
the
FCC rules. These limits are
designed
to
provide reasonable protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if
not
installed and used in accordance with the instructions,
may
cause
harmful interference
to
radio communications. However, there is no guarantee that interference will
not
occur
in a particular
installation. If this equipment does cause harmful interference
to
radio
or
television reception, which can be determined
by
turning
the
equipment
off
and on,
the
user is encouraged
to
try
to
correct
the
interference
by
one
or
more
of
the following
measures:
(a)
reorient
or
relocate
the
receiving antenna;
(b)
move this unit;
(c)
increase the separation between the equipment
and receiver;
(d)
connect
the
equipment into an outlet on a circuit different from that
to
which the receiver is connected;
(e)
be
sure
that
all cables are properly shielded, using a choke or ferrite where appropriate;
or
(f)
consult the dealer
or
an
experienced radio/television technician
for
help.
6