User Guide Guía del usuario Guide d’utilisation Guida per l’uso Benutzerhandbuch Appendix English ( 2 – 5 ) Español ( 6 – 9 ) Français ( 10 – 13 ) Italiano ( 14 – 17 ) Deutsch ( 18 – 21 ) English ( 22 – 23 )
User Guide (English) Introduction The DN-312X is an ultra-slim 1U rack-mounted 12-channel mixer with 6 mic/line combination inputs and 6 additional line inputs. It has balanced XLR outputs, a 1/4” (6.35 mm) mono output that can be used to connect the DN-312X to a remote mixer, a pair of RCA stereo outputs that can be used to connect to a remote recording device, and 1/4” (6.35 mm) mic monitoring port that can be used to monitor the mics’ signals.
Features Front Panel 3 5 4 6 8 7 9 10 2 11 1 1. Power Switch: Use this switch to power DN-312X on or off. 2. Power Light: This light illuminates when DN-312X is powered on. 3. Mic In Level: Turn these knobs to set the input level of the corresponding mic/line inputs (Channels 1–6). 4. Stereo In Level: Turn these knobs to set the input level of the corresponding line inputs (Channels 7/8–11/12). 5. Signal (Sig) Lights: Indicates that the channel’s incoming audio signal is within an optimal range. 6.
Rear Panel 1 2 10 3 8 9 11 5 7 6 4 1. AC Power Input: Use the included power cable to connect this input to a power outlet. Alternatively, use the DC power input, described below. (If both power inputs are connected to power outlets, DN-312X will draw its power from the AC power input.) 2. Fuse Cover: If the fuse is broken, use a screwdriver or other tool to lift this tab, and replace the fuse with a fuse with the same rating. Using a fuse with an incorrect rating can damage the unit and/or fuse. 3.
Setup Items not listed under Introduction > Box Contents are sold separately. To set up DN-312X with your sound system: ® 1. If you are using any audio source with RCA outputs (Blu-ray players, stereos, etc.), use standard RCA cables to connect them to the line inputs on the rear panel. Your audio sources must be line-level (no phono-level turntables). 2. If you are using microphones or other audio sources that send a line-level signal, connect them to the mic/line inputs on the rear panel. 3.
Guía del usuario (Español) Introducción El DN-312X es un mezclador de 12 canales ultra delgado de 1 U para montaje en rack con 6 entradas combinadas para micrófono/línea y seis entradas de línea adicionales. Cuenta con salidas XLR balanceadas, una salida mono de 6,35 milímetros (1/4 pulg.
Características Panel frontal 3 5 4 6 8 7 9 10 2 11 1 1. Interruptor de encendido: Utilice este interruptor para encender y apagar el DN-312X. 2. Luz de encendido: Esta luz se ilumina cuando el DN-312X está encendido. 3. Nivel de entrada de micrófono: Gire estas perillas para ajustar el nivel de entrada de las entradas de micrófono/línea mic/line inputs correspondientes (canales 1–6). 4.
Panel trasero 1 2 10 3 8 9 11 5 7 6 4 1. Potencia de corriente alterna de entrada: Utilice el cable de corriente incluido para conectar esta entrada a una toma de corriente. Como alternativa, utilice la entrada de corriente continua, descrita a continuación. (Si ambas entradas de corriente se conectan a tomas de corriente, el DN-312X consumirá la corriente de su fuente de corriente alterna). 2.
Ajustes Los elementos que no se enumeran en Introducción > Contenido de la caja se venden por separado. Cómo instalar el DN-312X a su sistema de sonido: ® 1. Si está utilizando una fuente de audio con salidas RCA (reproductores de Blu-ray , equipos de audio, etc.), utilice cables RCA estándar para conectarlos a las entradas line inputs del panel trasero. Sus fuentes de audio deben ser de nivel de línea (no giradiscos de nivel fonográfico). 2.
Guide d’utilisation (Français) Présentation Le DN-312X est un mixeur 12 canaux montés en rack 1U ultraplat avec 6 entrées combo micro/ligne et 6 entrées ligne supplémentaires. Il dispose de sorties XLR symétriques, une sortie mono 6,35 mm pouvant être utilisée pour relier une console de mixage à distance, une paire de sorties stéréo RCA pouvant être utilisée pour relier un appareil d’enregistrement à distance, et un port de monitoring des signaux microphone de 6,35 mm.
Caractéristiques Panneau avant 3 5 4 6 8 7 9 10 2 11 1 1. Interrupteur d’alimentation : Cet interrupteur permet de mettre le DN-312X sous et hors tension. 2. Indicateur d’alimentation : Ce voyant s’allume lorsque le DN-312X est sous tension. 3. Niveau des entrées microphone : Ces boutons permettent d’ajuster le volume des entrées microphone/ligne correspondantes (canaux 1–6). 4.
Panneau arrière 1 2 10 3 8 9 11 5 7 6 4 1. Entrée d’alimentation CA : Utilisez le câble d’alimentation fourni pour brancher cette entrée à une prise secteur. Vous pouvez également utiliser l’entrée d’alimentation CC, décrite ci-dessous. (Si les deux entrées d’alimentation sont reliées à des prises secteur, le DN-312 X est alimenté par l’entrée d’alimentation CA.) 2.
Installation Les éléments qui ne figurent pas dans Présentation > Contenu de la boîte sont vendus séparément. Configuration du DN-312X pour votre système audio : ® 1. Si vous utilisez une source audio avec sorties RCA (lecteurs Blu-ray , chaînes stéréo, etc.), utilisez des câbles RCA standard pour les relier aux entrées ligne du panneau arrière. Vos sources audio doivent être de niveau ligne (aucune platine phono). 2.
Guida per l’uso (Italiano) Introduzione Il DN-312X è un mixer 1U ultra sottile montato su rack a 12 canali con 6 ingressi combinati mic/linea e 6 ingressi di linea aggiuntivi.
Caratteristiche Pannello anteriore 3 5 4 6 8 9 7 10 2 11 1 1. Interruttore di alimentazione: servirsi di questo interruttore per accendere e spegnere il DN-312X. 2. Spia di alimentazione: si illumina quando il DN-312X viene acceso. 3. Mic In Level: girare queste manopole per impostare il livello di ingresso degli ingressi mic/linea corrispondenti (Canali 1–6). 4. Stereo In Level: girare queste manopole per impostare il livello di ingresso degli ingressi di linea corrispondenti (Canali 7/8–11/12). 5.
Pannello posteriore 1 2 10 3 8 9 11 5 7 6 4 1. Ingresso di alimentazione CA: servirsi del cavo di alimentazione in dotazione per collegare questo ingresso ad una presa di alimentazione. Alternativamente, servirsi dell’ingresso di alimentazione CC, descritto qui di seguito. (Se entrambi gli ingressi di alimentazione sono collegati a uscite di alimentazione, il DN-312X trarrà l’alimentazione dall’ingresso di alimentazione CA.) 2.
Configurazione Elementi non elencati sotto Introduzione > Contenuti della confezione sono venduti separatamente. Per configurare il DN-312X con il proprio impianto audio: ® 1. Se si utilizzano fonti audio con uscite RCA (lettori Blu-ray , stereo, ecc.), servirsi di cavi RCA standard per collegarle agli ingressi di linea presenti sul pannello posteriore. Le fonti audio devono essere a livello di linea (niente giradischi a livello fono). 2.
Benutzerhandbuch (Deutsch) Einführung Das DN-312X ist ein ultra-dünner 1U rack-montierbarer 12-Kanalmixer mit 6 Mic/Line-KombiEingängen und 6 zusätzlichen Line-Eingängen.
Funktionen Vorderseite 3 5 4 6 8 9 7 10 2 11 1 1. Netzschalter: Mit diesem Schalter schalten Sie das DN-312X ein oder aus. 2. Power-LED: Die LED leuchtet auf, wenn das DN-312X eingeschaltet ist. 3. Mic-Eingangspegel: Drehen Sie diese Regler, um den Eingangspegel der entsprechenden Mic/Line-Eingänge (Kanäle 1-6) einzustellen. 4. Stereo-Eingangspegel: Drehen Sie diese Regler, um den entsprechenden Line-Eingänge (Kanäle 7/8–11/12) einzustellen. Eingangspegel der 5.
Rückseite 1 2 10 3 8 9 11 5 7 6 4 1. AC-Eingang: Verwenden Sie das mitgelieferte Netzkabel, um diesen Eingang mit einer Steckdose zu verbinden. Wahlweise können Sie den DC-Eingang wie unten beschrieben verwenden. (Wenn beide Eingänge mit Steckdosen verbunden sind, bezieht das DN-312X seine Energie vom AC-Eingang.) 2.
Setup Teile, die nicht unter Einführung > Lieferumfang angegeben sind, sind separat erhältlich. So richten Sie das DN-312X mit Ihrem Sound-System ein: ® 1. Wenn Sie eine Audioquelle mit Cinch-Ausgängen verwenden (Blu-ray Players, Stereoanlagen etc.), benutzen Sie standardmäßige Cinch-Kabel, um sie an die rückseitigen Line-Eingänge anzuschließen. Bei Ihren Audioquellen muss es sich um Line-Level-Quellen handeln (keine Phono-Level-Plattenspieler). 2.
Appendix (English) Technical Specifications Input Channels Mic/Line Inputs (Channels 1–6) Microphone Input XLR+1/4” (6.35 mm) combination, electronically balanced, discrete input configuration Frequency Response 20 Hz – 22 kHz (+2 dBu) THD+N < 0.
Impedance Equalizer Crosstalk Mic/Line Input 1.4 kΩ Line Input > 10 kΩ All Outputs 120 Ω High +15 dB @ 12 kHz Mid +12 dB @ 2.5 kHz Low +15 dB @ 80 Hz Adjacent Inputs < -70 dB @ 1 kHz (Channels 1–6) < -68 dB @ 1 kHz (Channels 7/8–11/12) Main Mix Input Output < -82 dB @ 1 kHz (channel level @ max., EQ @ unity, master level & others @ min., input selectors set to Line) Line Output 0 dBu (+2 dBu), balanced (channel level, master level & EQ @ unity, all others at min.
denonpro.com Manual Version 1.