Manual

[3] VCB
• Other makes of components can be operated by setting the preset
memory for your make of video component.
This remote control unit can be used to operate components of
other manufacturers without using the learning function by
registering the manufacturer of the components as shown on the
List of Preset Codes (attached sheet)
Operation is not possible for some models.
ml
0000
.....® ®
,,,® G.........
0000
dO©©
0000
Im
1-a,b
©
000
o ©
,-0
DENON
1
Press the CLEAR button while pressing the TUNER/TV/VCR
remote control mode selector button,then input the 3 digit
number corresponding to the code of the manufacturer of the
VCR you want to store in the memory, referring to the
included table of remote control codes.
• Release the TUNER/TV/VCR button after inputting three
digits This completes the presetting operation
Example: To preset to Hitachi "072"
1
DENON remote-controllable audio components can be
controlled using this unit's remote control unit.
Note that some components, however, cannot be operated
with this remote control unit
Before operating the remote control unit!
Be sure to set the audio device mode using the _--_
remote control mode selector buttons.
a. For CDB recorder or MD recorder
TUNER)T_NOR
Pressthe buttons below while pressing TUNER/TV/VCR
HITACHI I_ (_ (_ (_
"072"
This iS set to Hitachi "072" by factory default.
NOTE:
• Some models and years of manufacture of components of the
manufacturers listed on the List of Preset Codes cannot be used.
• The unit is equipped with several types of remote control codes
which depend on the manufacturer. If there _s no operation,
please change the preset code (a 3-digit number) and try again.
4141,1_ : Manual search (reverse and fo)ward)
• : Stop
lib : Play
I_HI,I_I_I : Auto search
II : Pause
2O