Manual

[2] Setting the speaker distance
• input the distances from the listening position to the speakers and
set the surround delay time.
• The default settings be{ow are set upon shipment from the factory
Preparations:
Measure the distances from the {[stening position to the speakers (L1
to L3 on the diagram at the right).
Center FR
LI: Distance from center speaker to
listening position
L2: Distance from front speakers to
listening position
Ls: Distance from surround speaker to
listening position
./
SL SR
To perform these operations from places other than the
system setting change menu, see page 26
At the SYSTEM SETUP MENU se{ect "DELAY TIME"
Remote contro{ unit Remote control unit
• Switch to the DELAY TIME screen•
_ii DENON
ON] [_iETE_<FE_T j
_ON
ilii
• Use the { and ) cursor buttons to select the distance
unit, "METERS" or "FEET"
Press the v cursor button to proceed to the next step if
you do not wish to change this
When "YES" is selected for "DEFAULT", the delay times for
the various speakers are set to the default values.
Select the speaker to be set using the _. and v cursor
buttons, then setting the distance between the speakers and
the listening position using the ._. and v cursor buttons•
• Set the distance between the center speaker and listening
position.
The distance changes in units of 1 foot (0.1 meters) each
time the button is pressed• Select the va{ue closest to the
measured distance.
[_ _[_#_d_] DENON
I
[_ I=_ I ¸ _ I
[_ _HT_ I ¸ • I
._ The difference of the distances set for the different
speakers must be no greater than 10 ft (3.0 m)
If an inapplicable distance _s set, "CAUTION: iNVALID
DISTANCE" is displayed Change the speaker position and
reset•
Enter the setting.
• The SYSTEM SETUP MENU reappears
Remote control unit
YES: FRONT & SW * 9ft
CENTER *8ft
SURROUND 7ft
NO: The current settings are used
28