Manual

[] TROUBLESHOOTING
• Are all the connections correct ?
• Are you following the instructions in the manual ?
• Are the speakers and other components operating properly ?
If this unit does not seem to be functioning properly, check the table below. If this does not solve the problem, this unit may be damaged. Turn
off the power, unplug the power cord from the power outlet, and contact your store of purchase or nearest Denon sales office.
Symptom Cause Measures Page
DISPLAY not lit and sound not produced * Power cord not plugged in securely * Check the insertion of the power cord plug 8
when power switch set to on
J
• Speaker cords not securely connected * Connect securely 14
• improper position of the audio function • Set to a suitable position 35
button
DISPLAY Ik but soundnot produced • Volume control set to mlnlrnurn • Turnvolumeuptosukablelevel 36
o
• MUTING is on • Switch off MUTING 37
• Digital signals not input Digital input • input digital signals or select input jacks to 36
selected which digital signals are being input
• Connections between the video output jack • Check whether the connections are correct 9, 10, 12
of this unit and the input connector of the
monitor are _ncomplete
Monitor doesn't display an image • The input setting of the monitor TV is • Set the input switching of the TV to the jack --
._ different to which the video input is connected
o • Thevideosignalsofthevagousdevicesare • Make settings uniform for either composite 10, 12
not uniform video or S-video connectors
The program cannot be copied from DVD • Almost all movie software contains a copy • A copy cannot be made
to the VCR prevention signal
• Power is not being supplied to the • Switch on the power of the subwoofer --
® subwoofer
o • The subwoofer setting is made to "No' in • Change the setting to "Subwoofer" in the 26
_z The subwoofer does not produce sound
o_ the setup setup
E • The output of the subwoofer has not been • Make the proper connections 14
oE connected
C)
• The surround mode is set to a mode other • Set to auto decode 40
The test tone is not output than auto decode
• Replace with new batteries 18
• Move closer 18
• Remove obstacle 18
_c
This unit does not operate properly when
remote control unit is used
• Batteries dead
• Remote control unit too far from this unit
• Obstacle between this unit and remote
control unit
• Different button is being pressed
• _) and O ends of battery inserted in reverse
• The mode selection of the remote control is
not properly selected The DVD mode, AV
mode, or audio mode is not properly
selected
• Press the proper button
• Inset[ batteries properly
• Press the remote control mode sele_ion
button for the item you wish to operate¸ To
operate this unit, use with the DVD mode¸
17
18
17
85