User's Manual

16. Previous Track: Press this button to go to the previous audio track from a Bluetooth, USB, or SD

card source.

Note: When listening to Bluetooth sources, pressing this button may go to another playlist or music

genre in some apps.

17. Play/Pause: Press this button to play/pause an audio track from a Bluetooth, USB, or SD card

source.

18. Reverb: Adjust this knob to control the amount of reverb applied to the wired and wireless mic

channels.

19. Aux In 1 Volume: Adjust this knob to control the volume for the Aux 1 input.

20. Aux In 2 Volume: Adjust this knob to control the volume for the Aux 2 input.

21. 3-Band EQ: Adjust these knobs to control the treble, mid-range, and bass frequencies for the input

signal.

22. NFC (near-field communication): Touch and briefly hold your supported and enabled device to the

NFC logo to pair the device.

23. Wireless Antennas: Adjust the antennas to get the best wireless mic reception.

Rear Panel

1. Aux Input 1: Connect a line-level device, such as a CD player, laptop, smartphone, or media device, to

this 1/8” (3.5 mm) input.

2. Aux Input 2: Connect a line-level device, such as a CD player, tablet, smartphone, or media device to

these coaxial inputs.

3. USB Ports: Both USB ports are capable of 2.1A charging. The top USB port also supports USB flash

drive playback of WAV, MP3, and WMA files.

4. SD Card Slot: Connect a SD card here to play your WAV, MP3, and WMA files.

5. XLR+1/4”: Connect dynamic microphones to these mic inputs.

6. Mic/Line Switch: Press this switch in to have the gain set for mic level sources. Have the switch in the

outward position for line-level sources.

7. Line Output: Connect this 1/4” TRS (6.35 mm) output to another Audio Commander.

8. Wireless Receivers: Select the wireless mic channel using the Up/Down buttons and press the Set

button to link the channel to the wireless mic. See Operation > Wireless Microphone Setup for more

details.

Power Input: Connect the included power cable here.

Energy Saving Mode: Audio Commander will enter a low-power “sleep” mode after 60 minutes if no

Bluetooth music or audio input source is playing through it. To resume normal operation, press any

button.

10. Power Switch: Adjust this switch to power Audio Commander on/off.

11 12

2323