User's Manual

Operation

Wireless Microphone Setup

To use a wireless microphone, follow these setup steps:

1. Ensure 2 new AA alkaline batteries are installed in the wireless microphone.

2. Pair the wireless microphone (found in the side compartment) to W. Mic Receiver 01

on Audio Commander.

a. Turn on Audio Commander and the wireless microphone.

b. Select a channel with the best reception using the Up/Down buttons on the

receiver.

c. Place the wireless microphone IR sensor (found above the power button) near the

receiver’s IR LED and press the Set button on the receiver. Wait for about 3

seconds until the IR LED stops flashing. When it finds an interference-free

channel, the RF LED will illuminate on the receiver showing the mic is matched to

that channel.

3. Adjust the wireless microphone gain using the W. Mic 1 knob on Audio Commander.

4. As you speak, watch the AF indicator on W. Mic Receiver 01 to make sure a signal is

being received.

Note: Make sure to turn the Browse knob and select the appropriate W.Mic source

in order to output a signal.

To set up the second wireless microphone, follow the same steps above for pairing to W.

Mic Receiver 02.

Headset Microphone Setup

To use the included headset microphone, follow these setup steps:

1. Ensure new batteries are installed in the beltpack transmitter.

2. Connect the headset microphone to the beltpack transmitter.

3. Pair the beltpack transmitter to the wireless receiver on Audio Commander.

a. Turn on Audio Commander.

b. Turn on the beltpack transmitter.

c. Select a channel with the best reception using the Up/Down buttons on the

Audio Commander receiver.

d. Lift the cover from the compartment and place the beltpack transmitter IR sensor

near the receiver’s IR LED. Press the Set button on the receiver. Wait for about 3

seconds until the IR LED stops flashing. When it finds an interference-free

channel, the RF LED will illuminate on the receiver to show that the beltpack

transmitter is matched to that channel.

4. Adjust the microphone gain using the W. Mic knob on Audio Commander.

5. As you speak, watch the AF indicator on the receiver to make sure a signal is being

received.

Note: Make sure to turn the Browse knob and select the appropriate W.Mic source

in order to output a signal.