Operation Manual


Getting Started Connections Setup Remote Control Multi-Zone Information TroubleshootingPlayback
1
Connect the HDMI to the AVP-A1HD with equipment
compatible with the HDMI control function.
2
Put the power on for all the equipment connected to
the HDMI.
3
Check the settings for all the equipment connected to
the HDMI and make HDMI available to them.
b Please consult the operating instructions for the connected
equipment to check the settings.
b Operations 1 ~ 3 do not have to be repeated once started.
b Carryout Operations 2 and 3 should any of the equipment be
plugged out.
4
Switch the television input to the HDMI connected to
the AVP-A1HD.
5
Switch the AVP-A1HD input to the HDMI input
source and check if the picture from the player is ok.
6
Put the television power on standby and check if the
AVP-A1HD goes into standby.
If the AVP-A1HD does not work please check the following.
Is the GUI menu “Manual Setup” “HDMI Setup” “HDMI Control”
“Control” (vpage 31) set to ON”?
Is the GUI menu “Manual Setup” “HDMI Setup” “HDMI Control”
“Control Monitor” (vpage 31) set for the monitor output
connected to television?
Is the GUI menu “Manual Setup” “HDMI Setup” “HDMI Control”
“Power Off Control” (vpage 31) set to “ON”?
Is the control function used for the television HDMI properly set?
(Check the television operating instructions for details.)
Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat Operation's 2 and 3.
GUI menu “Source Select” (input source) – “Assign– “HDMI”
(vpage 43) setting has changed
There is a change to the connection between the equipment and
the HDMI, or an increase in equipment.
Change of HDMI monitor output in AVP-A1HD setup.
Operations
CH SELECT
<POWER>
<STANDARD>
<HOME THX CINEMA>
QUICK SELECT
uio p
uio p
CH SELECT
QUICK SELECT
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit