Operation Manual


Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting Specifications
1
Either turn <SOURCE SELECT> or press [SAT TU]
(AMP mode) to select “XM”.
: ”Source Select” (vpage 45)
2
To operate using the main remote control unit, set the
remote control unit to the TUNER ( ) mode.
(vpage 77 “Remote Control Unit Operations”)
3
Use [d f] to select the channel.
When the channel is tuned in, the name of the song and artist
are displayed.
• The channel switches continuously when [d f] is pressed and held.
• XM Radio channels can be preset using the same procedure as for
FM/AM stations (vpage 59, 60 “Presetting Radio Stations (Preset
Memory)” and “Listening to Preset Stations”).
• The artist name, song title, category and reception level can be
checked by pressing <STATUS>.
• The time for which the GUI menus are displayed can be set at
GUI menu “Manual Setup” – “Option Setup” – “GUI” – “Tuner”
(vpage 42).
Basic Operation
Checking the XM Signal Strength and
Radio ID
1
Either turn <SOURCE SELECT> or press [SAT TU]
(AMP mode) to select “XM”.
2
Press <STATUS> until “SIGNAL” appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display GUI Status
GOOD Signal strength is good
MARGINAL Signal strength is marginal
WEAK Signal strength is weak
NO No signal
3
Adjust the position of the antenna until “SIGNAL:
GOOD” is shown on the display.
4
Press <STATUS> until the channel (example:
“XM001”) is displayed.
5
Press [d f] and select channel 0 (XM000).
The radio ID is shown on the display.
The strength of both the XM satellite and terrestrial signals can be
checked at GUI menu “Source Select” – “XM” – “Antenna Aiming”
(vpage 49).
Radio ID
Accessing XM Radio Channels Directly
1
Press [SEARCH].
2
Press [NUMBER] then input the channel.
Example: Accessing channel “XM123”:
[1] → [2] → [3]
b If no button is pressed within several seconds, the channel
automatically switches to the one whose number has been input.
3
Press ENTER to set that channel.
Reception switches to the selected channel.
• “LOADING” is displayed while channels or data are being received.
• “XM - - -” is displayed if the selected channel cannot be used.
Searching Categories
1
Press o p.
2
Use o p to select the category, then use ui to select
the desired channel.
Channel category
Playback