Operation Manual


Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting Specifications
Convenient Functions
HDMI Control Function
When connecting the AVP-A1HDCI to a television or player compatible with the HDMI control function, the following operations are
possible.
• Turn power ON/OFF (Synchronize with television)
• Switch to sound output equipment (TV and AVP-A1HDCI)
• Adjust volume
• Switch input source
3-
065
015*$"-
065
"6%*0
"6%*0
R
L
R
L
065
)%.*
*/
)%.*
When using these functions set as follows: GUI menu “Manual Setup” – “HDMI Setup” – “HDMI Control” (vpage 32).
Connections
Player compatible
with HDMI
control function
Television compatible with
HDMI control function
NOTE
When using the HDMI control function, do not assign HDMI input to “TV/CBL” by setting “Source Select” – “(input source)” – “Assign” in the
GUI menu.
1
Connect the HDMI to the AVP-A1HDCI with
equipment compatible with the HDMI control
function.
2
Put the power on for all the equipment connected to
the HDMI.
3
Check the settings for all the equipment connected to
the HDMI and make HDMI available to them.
b Please consult the operating instructions for the connected
equipment to check the settings.
b Operations 1 ~ 3 do not have to be repeated once started.
b Carryout Operations 2 and 3 should any of the equipment be
plugged out.
4
Switch the television input to the HDMI connected to
the AVP-A1HDCI.
5
Switch the AVP-A1HDCI input to the HDMI input
source and check if the picture from the player is ok.
6
Put the television power on standby and check if the
AVP-A1HDCI goes into standby.
If the AVP-A1HDCI does not work please check the following.
• Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI Control”
– “Control” (vpage 32) set to “ON”?
• Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI Control”
– “Control Monitor” (vpage 32) set for the monitor output
connected to television?
• Is the GUI menu “Manual Setup” – “HDMI Setup” – “HDMI Control”
– “Power Off Control” (vpage 32) set to “ON”?
• Is the control function used for the television HDMI properly set?
(Check the television operating instructions for details.)
• Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat Operation's 2 and 3.
•
GUI menu “Source Select” – (input source) – “Assign” – “HDMI”
(vpage 48) setting has changed
•
There is a change to the connection between the equipment and
the HDMI, or an increase in equipment.
•
Change of HDMI monitor output in AVP-A1HDCI setup.
Operations
Playback