Owner's Manual

I
-AUDIQ-
- AUDIO-
OPTICAL OPTICAL
IN
IN
[£]
~
I
I
ZONE2 or ZONE4 Optical Connections
The AVP-A1 HDCI is equipped with Optical output connectors for ZONE2 and ZONE4. If a bit-stream amp
is rigged-up, these zones can also be used to enJoy home theater.
AV amplifier AV amplifier
(ZONE2) (ZONE4)
'~(.)i.
• For the audio output. use high quality pin-plug cords so that no induction humming or noise is produced.
•
For instructions on installing and operating separately sold devices, refer to the respective devices'
operating instructions.
•
To conduct multi-zone playback, see "Multi-Zone Connections and Operations" l(1f'page 82, 83).
• Connect the monitor for ZONE2 the same as the "ZONE2 or ZONE3 Pre-out Connectors" ((1f'See left
column)
• If the signal Inputted to ZONE2 is analog, change to PCMI2-channel) signal, and output it from ZONE2
optical output connectors.
Power
amplifier
-AUDIQ-
AUDIO
IN
L R
~~
.P:r
, I'=;a=a=a=;='
ZONE3
Monitor
- VIDEO-
Extension Jack for future use.
Infrared
sensor
Monitor -----------,.
ZONE2
Power
amplifier
~AUDIO-
AUDIO
IN
L R
~~
ZONE2 or ZONE3 Pre-out Connections
·If another power amplifier or pre-main lintegrated) amplifier is connected, the ZONE2 or ZONE3 pre-out
Ivariable or fixed level) connectors
can be used to playa different program source in ZONE2 or ZONE3
the same time ((1f'page
82, 83) .
•
To the monitor output of ZONE2, various formats of video signals input by the video conversion function
are automatically converted and output ((1f'page 9),
• To the monitor output of ZONE3, video signals input from the S video terminal or video terminal is output
((1f'page
9).
• The ZONE2 (ZONE31 video out is only for ZONE2 (ZONE3).
AUX
OUT Input
Infrared. f
l
;:
~;;;;;;;;~c:::J~;;;I~m.!.-~
retransmltter ~~~~~3Eil
" G
22