Operation Manual


Getting Started Connections Settings Remote ControlMulti-zone Information Troubleshooting Specifications
ENGLISH
When you make an HDMI connection with a TV or player compatible
with AVR-3310 and HDMI control functions, you can perform the
following operations by setting the HDMI control function of each
device.
When you want to listen to TV audio by AVR-3310, connect optical
digital or analog audio (vpage 15 “Connecting the Monitor (TV)”).
When using these functions set as follows: “HDMI Control”
(vpage 35) set to “ON”.
•
•
NOTE
When “HDMI Control” is set to “ON”, it consumes more standby
power.
The HDMI control function controls operations of a TV that is
compatible with the HDMI control function. Make sure that the TV
and HDMI are connected when you perform HDMI control.
When you power off AVR-3310, the HDMI control function does not
operate. Either power on or set to standby.
Some functions may not operate depending on the connected TV
or player. Check the owner’s manual of each device for details
beforehand.
When “HDMI Control” is set to “ON”, it is not possible to assign an
HDMI terminal to “TV” at “Input Assign” (vpage 45).
•
•
•
•
•
1
Turn the power on for all the equipment connected
by HDMI cable.
2
Set the HDMI control function for all equipment
connected by HDMI cable.
Set “HDMI Control” (vpage 35) to “ON“.
Please consult the operating instructions for the connected
equipment to check the settings.
Carryout steps 1 and 2 should any of the equipment be plugged
out.
b
b
3
Switch the television input to the HDMI connected to
the AVR-3310.
4
Switch the AVR-3310 input to the HDMI input source
and check if the picture from the player is ok.
5
When you turn the TV’s power to standby, check
that the power of the AVR-3310 and player also goes
on standby.
If the HDMI control function does not operate properly, check the
following points.
Is the TV or player compatible with the HDMI control function?
Is the AVR-3310 properly set?
Is the “HDMI Control” (vpage 35) set to “ON”?
Is the “Power Off Control” (vpage 36) set to “ON”?
Are the HDMI control function settings of all equipment correct?
•
•
•
•
•
NOTE
Should any of the operations below be performed, the interlocking
function may be reset, in which case, repeat step’s 1 and 2.
“Input Assign” – “HDMI” (vpage 45) setting has changed.
There is a change to the connection between the equipment and the
HDMI, or an increase in equipment.
•
•
AVR-3310 power off can be linked to the TV power
off step.
When you set “Output audio from amp” in the TV audio output
setup operation, you can switch the amp power on.
You can switch audio output devices with a TV
operation.
You can adjust AVR-3310 volume in the TV volume
adjustment operation.
You can switch AVR-3310 input source through
linkage to TV input switching.
When playing the player, the AVR-3310 input function
switches to the function of that player.
n
n
n
n
n
HDMI Control Function
Convenient Functions
Playback