Operation Manual


Getting Started Connections Settings Playback Remote Control Information Troubleshooting Specifications
The operating procedure is the same for “q Zone Playback by Speaker
Output” and “w Zone Playback by Audio Output (PRE OUT)”.
Playback
1
Press <POWER>.
2
Turn on the zone power.
Operation on the main unit
Press <ZONE2 ON/OFF> or <ZONE3 ON/OFF> for the
zone to be operated.
When the power turns on, the “ ” or “ ” indicator lights
on the display.
Operation on the remote control unit
q Set the main remote control unit’s [DEVICE SELECT]
shown on below.
w Press [ZONE ON].
When the power turns on, the “ ” or “ ” indicator lights
on the display.
Also press [INPUT SOURCE SELECT] when in standby mode, the
power turns on.
When using ZONE2 or ZONE3, it is possible to turn the power for
the MAIN ZONE only on or off by pressing [MAIN ON] or [MAIN
OFF].
b
b
3
Select the input source.
Operation on the main unit
q Press <ZONE2/3/ REC SELECT> and select the zone to
be adjusted.
w Turn <SOURCE SELECT> to choose the input source.
Operation on the remote control unit
In the zone mode you want to operate, press [INPUT
SOURCE SELECT].
The same input source as in the main zone can be selected easily
by pressing the [M.ZONE CALL] on the sub remote control unit.
b
4
Adjust the item below.
Adjust the Volume
Operation on the main unit
q Press <ZONE2/3/ REC SELECT> and select the zone
to be adjusted.
w Turn <MASTER VOLUME> to adjust.
Operation on the remote control unit
In the zone mode whose volume you want to adjust,
press [VOLUME].
GAdjustable rangeH
– – – –80dB ~ –40dB ~ 18dB
(When the “Volume Display” setting is “Relative”)
GAdjustable rangeH
0 ~ 41 ~ 99
(When the “Volume Display” setting is “Absolute”)
Upon purchase, “Volume Limit” is set to “-10dB (71)”.
Turning off the Sound Temporarily (MUTE)
In the zone mode for which you want to mute the
sound, press [MUTE].
The sound is reduced to the level set at menu “Mute Level”
(vpage 41).
To cancel, either adjust the volume or press [MUTE] again.
The setting is canceled when the zone’s power is turned off.
n
b
n
b
b
<ZONE2/3 / REC SELECT>
<POWER>
<ZONE2 ON/OFF>
<MASTER VOLUME>
<ZONE3 ON/OFF>
QUICK SELECT
<SOURCE SELECT>
QUICK SELECT
[VOLUME]
[MUTE]
[INPUT
SOURCE
SELECT]
Button located on both the main unit
and the remote control unit BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control unit [BUTTON]
Symbols used to indicate buttons in this manual
[MAIN OFF]
[ZONE ON]
[MAIN ON]
[INPUT
SOURCE
SELECT]
Multi-zone
[M.ZONE CALL]
Sub remote control unit
Front Rear