Operation Manual


Getting Started Connections Settings Playback Information Troubleshooting Specifications
It is also possible to save three settings for multi-zone.
GQuick Select DefaultsH
Input Source Volume
Z2/Z3 Quick Select 1 DVD –40dB
Z2/Z3 Quick Select 2 SAT/CBL –40dB
Z2/Z3 Quick Select 3 VCR –40dB
1
Set the items below to the settings you want to save.
q Input Source (vpage 85)
w Volume Level (vpage 85)
2
In the zone mode for which you want to operate, press
and hold the desired QUICK SELECT until “Memory”
appears on the display.
The current settings will be memorized.
Quick Select Function
Multi-zone
Naming Quick Select settings
See “Quick Select Name” (vpage 42).
n
Press QUICK SELECT at which the settings you want to
call out are saved.
Calling the Settings Out
Operating the Connected Devices by Remote Control
Unit
Operating the Main Remote
Control Unit
[DEVICE
SELECT 1]
[DEVICE
SELECT 2]
Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
VDP (Video Disc Player) can be preset when [DEVICE SELECT 2] is
set to “DVD/HDP”.
The preset memory can be set for one component only among the
following: TV, DVD/HDP, DVR/VCR, SAT/CABLE and CD.
Depending on the model and year of manufacture of your equipment,
some buttons may not operate.
•
•
•
•
DENON and other makes of components can be operated by setting
the preset memory.
1
Switch [DEVIDE SELECT 1].
MAIN/TV
: To register a TV
DEVICE
: To operate a Blu-ray disc player, DVD player, Digital
video recorder, video deck, satellite receiver,
cable TV or CD player
2
Set [DEVIDE SELECT 2] to the component to be
registered.
TV
: TV
DVD/HDP
: DVD player or Blu-ray disc player
DVR/VCR
: Digital video recorder or video deck
SAT/CBL
: Satellite receiver or cable TV
CD
: CD player
3
Press [ZONE OFF] and [MAIN ON] at the same time.
The indicator starts flashing.
4
Press [0 ~ 9] and input the 3-digit number of the
brand of the component to be preset. The numbers
are shown in the Preset Code Table (vEnd of this
manual).
5
To store the codes of another component in the
memory, repeat steps 1 to 4.
Remote Control
[MAIN ON]
[ZONE OFF]
[0 ~ 9]
Front Rear
Registering Preset Codes