User's Guide


Getting Started Connections Playback Remote ControlMulti-zone Information Troubleshooting Specifications
See overleaf
Making Detailed Settings (Manual Setup)
Setting
Setting items Setting contents
EQ Customize
(Continued)
Audyssey Flat : Set when not using the “Audyssey Flat” equalizer.
Used : Use.
Not Used : Do not use.
Set so that “Audyssey Flat” settings can be made when Audyssey
Auto Setup procedure is performed.
•
•
Manual : Set when not using the “Manual” equalizer.
Used : Use.
Not Used : Do not use.
•
•
Make network settings.
Setting items Setting contents
Network Connecting
Make settings for wired
LAN.
1. Connect the LAN cable (vpage 23 “Connecting to a Home Network
(LAN)”).
2. Turn on the AVR-3310CI (vpage 24 “Turning the Power On”).
AVR-3310CI performs automatic network setup due to the DHCP
function.
When connecting to a network that has no DHCP function, perform the
setting in step 3.
3. Set the IP address at the “Network Connecting”.
q
r
e
Making the Network Settings (Network Setup)
Default settings are underlined.
Setting items Setting contents
Network Connecting
(Continued)
q On the GUI menu, select “Network Connecting” – “Detail” and
press ENTER.
w Use o p to set “DHCP” to “OFF”, then press i.
The DHCP function is disabled.
e Use uip to input the address and press ENTER.
IP Address
: Set the IP address within the ranges shown below.
The Network Audio function cannot be used if other IP addresses
are set.
CLASS A: 10.0.0.0 ~ 10.255.255.255
CLASS B: 172.16.0.0 ~ 172.31.255.255
CLASS C: 192.168.0.0 ~ 192.168.255.255
Subnet Mask : When connecting an xDSL modem or terminal
adapter directly to the AVR-3310CI, input the subnet mask
indicated in the documentation supplied by your provider. Normally
input 255.255.255.0.
Default Gateway : When connected to a gateway (router), input
its IP address.
Primary DNS, Secondary DNS : If there is only one DNS address
indicated in the documentation supplied by your provider, input it
at “Primary DNS”. If there are two or more DNS addresses, input
the first one at “Secondary DNS”.
r Use i to select “Exit” and press ENTER.
Setup is complete.
When connecting to the network via a Proxy server, select “Proxy” and
press ENTER (vpage 39 “Proxy settings”).
If you are using a broadband router (DHCP function), there is no need
to make the settings at “IP Address” and “Proxy”, since the DHCP
function is set to “ON” in the AVR-3310CI’s default settings.
If the AVR-3310CI is being used connected to a network without the
DHCP function, the network settings must be made. In this case, some
knowledge of networks is required. For details, consult a network
administrator.
If you cannot connect to the Internet, recheck the connections and
settings (vpage 23).
If you do not understand about Internet connection, contact your ISP
(Internet Service Provider) or the store from which you purchased your
computer.
When you want to cancel the setting during IP address input, press
RETURN.
•
•
•
•
b
•
•
•
•
•
Main remote control
operation buttons
:Displaying the menu
Cancel the menu
:Moves the cursor
(Up/Down/Left/Right)
:Confirm the setting :Return to previous menu
w