User's Guide


Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting Specifications
Tuning in Radio Stations – SIRIUS Satellite Radio
“UPDATING” is displayed while the encording code is being
updated.
“SIRIUS UPDATING” is displayed when updating SIRIUS tuner
firmware.
Refer to “Troubleshooting” – “SIRIUS Satellite Radio” (vpage
103) regarding other messages.
•
•
•
1
Tune to the channel you want to lock.
2
Press ENTER for at least 3 seconds.
“Enter Lock Code” is displayed.
3
Enter the 4-digit lock code using uio p.
When you enter the correct code, the corresponding channel
is locked.
4
Press ENTER.
Channels under Parental Lock cannot be tuned in by performing
Tuning Up/Down or by category search.
Channels stored in preset memory can be tuned in by the preset
channel select operation, even if Parental Lock is applied.
When a channel to which Parental Lock is applied is being played,
Parental Lock for that channel is cancelled by performing step 2.
See “Edit Lock Cord” (vpage 51) for the method of changing
Parental Lock Cord.
You can also set “Parental Lock” (vpage 51) from the menu.
•
•
•
•
•
Parental Lock
1
Press o p.
S R 0 0 1 H i t s 1
C A T : P o p s
2
Use o p to select the category, to use ui to select
the desired channel.
Channel category
Searching Categories
Playback Playback
Presetting Radio Channels (Preset Memory)
Your favorite broadcast channels can be preset so that you can tune
them in easily. Up to 56 channels can be preset.
To preset other channels, repeat steps 1 to 4.
NOTE
Preset channels are erased by overwriting them.
Listening to Preset Channels
You can also operate via the main unit. In this case, perform the
following operations.
Press <TUNING PRESET>, then turn <SOURCE SELECT> to select the
preset radio channel.
Press [CHANNEL] to select the desired preset channel,
then press ENTER.
1
Tune in the broadcast channel you want to preset.
2
Press [MEMORY].
3
Press [SHIFT] to select the block in which the channel
is to be preset, then press [CHANNEL] to select the
preset number.
4
Press [MEMORY] again to complete the setting.