Protocol Specs

- 19 -
Z3 COMMAND : "*" parameter uses two ASCII characters. (see page4 J) section)
Except Japan model
COMMAND PARAMETER
function example
Z3 PHONO MULTI ZONE-3 mode set , and select source at AVR-3808 Z3PHONO<CR>
| ---The name of PARAMETER is |
IPOD
the same as that of the time of SI COMMAND. Z3IPOD<CR>
SOURCE MULTI ZONE-3 mode cancel Z3SOURCE<CR>
UP MULTI ZONE-3 VOLUME UP/DOWN , direct change to **dB Z3UP<CR>
DOWN Z3DOWN<CR>
** **:10 to 99 by ASCII , 80=0dB, 99=---(MIN) Z380<CR>
ON MULTI ZONE-3 ON/OFF change at AVR-3808 Z3ON<CR>
OFF Z3OFF<CR>
? Return Z3 Status Z2?<CR>
Z3MU ON ZONE3 OUTPUT MUTE ON/OFF change Z3MUON<CR>
OFF Z3MUOFF<CR>
? Return Z3MU Status Z3MU?<CR>
Z3CS ST
ZONE3 Channel setting
Z3CSST
MONO Z3CSMONO
?
Return Z3CS Status
Z3CS?
Z3CV FL UP
ZONE3 CHANNEL VOLUME UP/DOWN , direct change to **dB
Z3CVFL UP<CR>
FL DOWN
---FRONT Lch
Z3CVFL DOWN<CR>
FL **
**:38 to 62 by ASCII , 50=0dB
Z3CVFL 50<CR>
FR UP
ZONE3 CHANNEL VOLUME UP/DOWN , direct change to **dB
Z3CVFR UP<CR>
FR DOWN
---FRONT Rch
Z3CVFR DOWN<CR>
FR **
**:38 to 62 by ASCII , 50=0dB
Z3CVFR 50<CR>
?
Return Z2CV Status
Z3CV?<CR>
Z3HPF ON
ZONE3 HPF ON/OFF
Z3HPFON<CR>
OFF Z3HPFOFF<CR>
?
Return Z3HPF Status
Z3HPF?<CR>