Operation Manual


Getting Started Setup Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
Specifications
USB Port
In the initial status, USB memory devices can be used by connecting them to the USB port on the front panel.
To change the port to be used, see “USB Select” on page 43.
For instructions on playing the files on a USB memory device, see page 62, 63.
NOTE
Set to the USB port you want to use.
The AVR-4308 is equipped with two USB ports, one each on the front and rear panels. It is not possible to use the set with USB memory
devices connected to both the ports at the same time. Select the USB port you want to use at the GUI menu “Source Select” – “NET/USB”
“Playback Mode” – “USB Select”.
n Front panel n Rear panel
USB memory device USB memory device
Do not use the extension cable for connecting the USB memory device to the AVR-4308’s USB port.
Use of the extension cable may cause harmful interference.
Connections