Operation Manual



Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting

ENGLISH

Speciﬁcations

Last Function Memory

This stores the settings as they were directly before the

standby mode was set.

When the power is turned back on, the settings are

restored to as they were directly before the standby mode

was set.

Backup Memory

The various settings are backed up for about 1 week,

even if the power is turned off or the power cord is

disconnected.

Resetting the Microprocessor

Perform this procedure if the display is abnormal or if

operations cannot be performed.

When the microprocessor is reset, all the settings are

reset to their default values.

Turn off the power using <POWER>.

Press <POWER> while simultaneously pressing

<STANDARD> and <DSP SIMULATION>.

Once the display starts ashing at intervals of about 1

second, release the two buttons.

If in step 3 the display does not ﬂash at intervals of about 1 second,

start over from step 1.

Playback