Operation Manual

0
Getting Started Connections Settings Playback Multi-zone Information Troubleshooting Specifications
ENGLISH
Operating the Main Remote Control Unit
[MUTE]
[ iPod]
[ NET/USB]
[0 ~ 9]
[POWER ON]
[DEVICE
SELECTOR]
[POWER OFF]
[RC SETUP]
[MASTER
VOLUME]
[SOURCE
SELECT]
[ MAIN]
[ TUNER]
When using multiple DENON AV receivers in the same room, make
this setting so that only the desired AV receiver operates.
Setting the Remote ID
NOTE
When changing a setting, be sure to set the same remote ID as the
AVR-4310’s (vpage 43).
When changing the MAIN mode’s remote ID, also change the
“TUNER”, “iPod”, and “NET/USB” remote ID at the same time.
•
•
DEVICE SELECTOR
Remote ID
MAIN TUNER iPod NET/USB
1
(Default)
81001 62863 72815 62865
2 82001 62275 72816 62837
3 83001 62276 72817 62838
4 84001 62277 72818 62839
1
Press [MAIN] to light the “MAIN” zone indicator.
2
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
3
Refer to the table at the right, and use [0 ~ 9] to input
the 5-digit number corresponding to the remote ID
to be changed.
The signal transmission indicator flashes twice.
4
Press [TUNER], [iPod] or [NET/USB] to select the
mode to be set.
5
Repeat steps 2 to 4 to set the remote IDs for all
modes.
Signal
transmission
indicator
[0 ~ 9]
[DEVICE
SELECTOR]
[MACRO]
[RC SETUP]
Signal
transmission
indicator
If your AV devices are of a brand other than DENON or if they cannot
be operated with the preset memory function, their remote control
signals can be transfered to stored in the AVR-4310’s main remote
control unit.
Learning Function
1
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice.
2
Press [9], [7] and [5], in that order.
The signal transmission indicator flashes twice and the learning
mode is set.
3
Press [DEVICE SELECTOR] for the device you want
to set
4
Press the button to be set.
The main remote control unit’s display turns off.
If a button that cannot be learned is pressed, the signal transmission
indicator lights but the signal is not learned.
b
5
Point the main remote control units directly at each
other and press and hold the button on the other
device’s remote control unit that you want to learn.
Once learning is completed normally, the display lights and the
signal transmission indicator flashes twice.
If you want to learn other buttons, repeat steps 4 and 5.
The mode can be switched by pressing [DEVICE SELECTOR].
The signal transmission indicator lights once for a long time if
learning was not possible
b
b
b
6
Press and hold in [RC SETUP] for at least 3 seconds.
The signal transmission indicator flashes twice and the setting
is completed.
[0 ~ 9]
[CHANNEL +, –]
[ DVD/HDP]
[ SAT/CBL]
[ VCR/DVR]
[ TV]
[DEVICE
SELECTOR]
[8], [1],
[9], [6],
[3], [7], [2]
[RC SETUP]
[ MAIN]
Signal
transmission
indicator
Remote Control