Operation Manual
25
4
Select the mode.
Select “Auto” or “Manual”.
• Auto:
Adjust the level while listening to the test tones produced automatically
from the different speakers.
• Manual:
Select the speaker from which you want to produce the test tone to
adjust the level.
Example: When the “Auto” mode is selected
5
Select “Surr. Sp.”, then select the surround speaker(s) from which you want to produce the test
tone (A, B or A+B).
• Surr. Sp.: A
Adjusts the balance of the playback level between the channels when using surround speaker
A.
• Surr. Sp.: B
Adjusts the balance of the playback level between the channels when using surround speaker
B.
• Surr. Sp.: A+B
Adjusts the balance of the playback level between the channels when using surround
speakers A and B at the same time.
The “Surr. Sp.” can only be selected when both surround speakers A and B have been
selected at the “Speaker Configuration” (when both A and B have been set to “Large” or
“Small”).
Select “Test Tone Start”.
6
7
Select “Ye s”.
8
a. If the “Auto” mode is selected:
Test tones are automatically emitted from the different speakers.
The test tones are emitted from the different speakers in the
following order, at 4-second intervals the first time and second time
around, 2-second intervals the third time around and on:
Use the CURSOR buttons to adjust all the speakers to the same
volume.
The volume can be adjusted between –12 dB and +12 dB in units of
0.5 dB.
b. When the “Manual” mode is selected
Move jog stick “ENTER” back and forth to select the speaker for which
you want to output test tones, then move jog stick “ENTER” left and
right to adjust so that the volume of the test tones from the various
speakers is the same.
Example: When the volume is set to –11.5 dB
while the test tone is being
produced from the FL.
Example: When the volume is set to –11.5 dB
while the FL is selected.
Flashing
Flashing
FL C FR SR SBR SBL SL SW
SB
1spkr
2spkrs
When the surround back speaker setting is set to “1spkr” for
“Speaker Configuration”, this is set to “SB”.