Operating instructions

PageDefault settingsItems
43
PageDefault settingsItems
Advanced Setup – Part 1
Advanced Setup – Part 1
1. Auto Setup/Room EQ
1 Auto Setup
Room EQ
Setup
2
Direct Mode
Setup
4
3
Mic Input
Select
–
All, Room EQ = OFF
OFF
Mic
9 ~ 12
60
60
61
System setup items and default values
2. Speaker Setup
1
3
Speaker
Config.
Channel
Level
Front Sp.
Large
Center Sp. Surround Sp.Subwoofer
Small SmallYes
Surround
L & R
Center
Front
L & R
Subwoofer
10 ft (3.0 m)12 ft (3.6 m)12 ft (3.6 m) 12 ft (3.6 m)
Front
L
Front
R
Center Surround R Subwoofer
0 dB 0 dB 0 dB 0 dB 0 dB
Surround Back
Sp.
Small / 2spkrs
4
Distance
Surround L
0 dB
Crossover
Frequency
5
80 Hz
56, 57
2
Subwoofer
Setup
LFE
57
57, 58
58, 59
59
Surround
Back
10 ft (3.0 m)
Surround
Back R
0 dB
Surround
Back L
0 dB
This unit performs an analysis of the speaker system and
measures the acoustic characteristics of your room to permit
an appropriate automatic setting.
Set the Room Equalizer setting with “All” or “Assign” for
each surround mode.
Set the ON/OFF setting of Room Equalizer, in the case of the
surround mode is in “Direct” or “Pure Direct”.
Sets whether the setup microphone is connected to the pin
jack (V. AUX L channel) or mIni jack (SETUP MIC).
Automatically set the output component and properties for
the various channels according to the combination of
speakers to be actually used for surround playback.
This parameter is for optimizing the timing with which the
audio signals are produced from the speakers and
subwoofer according to the listening position.
Set the volume of the various speakers so that the sound
output from the speakers and the subwoofer seems to have
the same volume level.
Select the method of playback of the subwoofer for playing
the low bass signals.
Set the frequency (Hz) below which the bass sound of the
various speakers is to be output from the subwoofer.