Protocol Specs
- 4 -
NETWORK SETUP of AVR-X2000/E400
>Procedure of Network Setup mode.
(1)Press SETUP MENU button, then Menu appears on FL-display(and GUI)
(2)Select “Setup Menu > Network > Settings ” .
(3)Set parameters described below.
<DHCP> "On"---Use this setting when DHCP server is on the local network.
"Off"---Use this setting when DHCP server is not on the local network.
<IP Address> When <DHCP> sets "Off”, please set IP address.
When <DHCP> sets "On”, you can confirm the IP address that is set by server.
<Subnet Mask> When <DHCP> sets "Off”, please set Subnet Mask.
When <DHCP> sets "On”, you can confirm the Subnet Mask that is set by server.
<Gateway> Set the address of Gateway when Gateway is on the local network.
Do not set this parameter when Gateway is not on the local network.
<Primary DNS> Do not set this parameter.
<Second DNS> Do not set this parameter.
<Proxy> Set this parameter "Off".
<Network Option: IP Control>
(1)Press SETUP MENU button, then Menu appears on FL-display (and GUI)
(2)Select “Setup Menu > Network > IP Control”
(3)Set parameters described below.
“Always On”---Use this setting when using the AVR-X2000/E400 Connected in a network.
“Off In Standby”--- Use this setting when not using the AVR-X2000/E400 connected in a network.
This setting is reducing the power consumption in the standby mode.