Owner's Manual
Table Of Contents
- Getting Started
- Owners Manual (Supplied on CD-ROM)
- Reset
- Features
- Table of Contents
- Video Conversion
- Supplied Accessories
- Parts & Controls
- Basic Version
- Advanced Version
- Using the Remote Control
- Surround Modes and Parameters
- Types of Input Signals and Corresponding Surround Modes
- Relationship Between Video Signals and Monitor Output
- Video Signal Resolution Conversion Table
- Glossary
- Troubleshooting
- Specs
- Index
- Scan of CD-ROM
- Warranty
94
Set up speakers
NOTE
After performing Audyssey
®
Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey
®
Setup again.
10
Use o p to set whether or not a
subwoofer channel is measured,
and then press ENTER.
Measure Set for measuring a subwoofer.
Skip
Set for no measuring of a subwoofer.
11
Use o p to set whether or not a surround back
channel is measured, and then press ENTER.
Measure
(2spkrs)
Set for measuring two surround back speakers.
Measure
(1spkr)
Set for measuring a surround back speaker.
Skip
Set for no measuring of a surround back speaker.
12
Use o p to set whether or not a front height channel
is measured, and then press ENTER.
Measure Set to measure the front height speakers.
Skip
Set when you do not want to measure the front height
speakers.
13
Use o p to set whether or not a front wide channel is
measured, and then press ENTER.
Measure Set to measure the front wide speakers.
Skip
Set when you do not want to measure the front wide
speakers.
14
Press o or BACK.
Proceed to page31
Preparation
step 5.
Basic version
Advanced version
Informations
Advanced version
DVD