Owner's Manual
Table Of Contents
- Getting Started
- Owners Manual (Supplied on CD-ROM)
- Reset
- Features
- Table of Contents
- Video Conversion
- Supplied Accessories
- Parts & Controls
- Basic Version
- Advanced Version
- Using the Remote Control
- Surround Modes and Parameters
- Types of Input Signals and Corresponding Surround Modes
- Relationship Between Video Signals and Monitor Output
- Video Signal Resolution Conversion Table
- Glossary
- Troubleshooting
- Specs
- Index
- Scan of CD-ROM
- Warranty
86
FL FR
C
SL
SR
SW
SB
Connecting 6.1-channel speakers using one surround back
speaker
If using only one surround back speaker, connect to the “L” side of the SURROUND BACK terminal.
For speaker settings in this case, see “When 6.1ch speakers are installed” (vpage83).
To perform 6.1-channel playback using the surround back speaker, set “Assign Mode” to “Main Only” in
steps 3 to 5 for “Set up “Amp Assign”” (vpage92).
Also use the “Speaker Config.” setting (vpage131) to set “Surr.Back” to “1spkr”.
Cables used for connections
Audio cable (sold separately)
Speaker
cable
Subwoofer
cable
NOTE
•For speaker cable connections, see page84.
•For speaker impedance , see page84.
Speaker connection
Basic version
Advanced version
Informations
Advanced version
DVD