User Manual

o
Speakers for ZONE2 / Speakers for ZONE3 /
Speakers for ZONE2/ZONE3 / Speakers for Bi-
Amp/ Speakers for 2ch/ Speakers for Front B
When “Assign Mode” is set to “9.1ch + ZONE2”, “9.1ch + ZONE3”,
“9.1ch + ZONE2/3-MONO”, “7.1ch + ZONE2/3”, “9.1ch (Bi-Amp)” or
“9.1ch + Front B” in the menu, select the speaker terminal from which
to output the channels to which the internal amplifier is assigned.
(v
p. 214)
HEIGHT 1:
The assigned channels are output from
the HEIGHT1 speaker terminals. The
height, ceiling, and Dolby Atmos Enabled
channels cannot be used.
HEIGHT 2
(Default):
The assigned channels are output from
the HEIGHT2 speaker terminals. Up to
one set of height, ceiling, and Dolby
Atmos Enabled channels can be used.
SURROUND BACK:
The assigned channels are output from
the SURROUND BACK speaker
terminals. The surround back channel
cannot be used.
o
Floor
n
Layout
Select the floor speakers location.
5ch & SB
(Default):
This layout combines a surround back
speaker with the basic 5-channel layout.
5ch：
This is a basic 5-channel layout that uses
front speakers, center speakers and
surround speakers.
Contents Connections Playback Settings Tips Appendix
216
Front panel Display Rear panel Remote Index