Owner`s manual

218
Appendix
SettingsPlaybackConnections
Contents
Front panel Display Rear panel IndexRemote
Tips
Symptom Cause/Solution Page
DTS sound is not output. •Check that the digital audio output setting on the connected device is set to “DTS”.
•Set “Decode Mode” on the menu to “Auto” or “DTS”.
–
171
Dolby TrueHD, DTS-HD, Dolby Digital
Plus audio is not output.
•Make HDMI connections.
•Check the digital audio output setting on the connected device. On some devices, “PCM” is
set by default.
41,42,43
–
Dolby PLg mode or DTS NEO:X mode
cannot be selected.
•It cannot be selected when “None” is set for “Speaker Config.” – “Center” and “Surround”.
•These cannot be selected when using the headphones.
183
–
Audyssey MultEQ® XT32, Audyssey
Dynamic EQ®, Audyssey Dynamic
Volume® and Audyssey LFC™ cannot
be selected.
•These cannot be selected when you have not performed Audyssey® Setup.
•Switch the sound mode to other than “DIRECT” or “PURE DIRECT”.
•These cannot be selected when using the headphones.
172
110
–
Audyssey DSX® cannot be selected. •It can be selected when using the front height or front wide speakers.
•It can be selected when using the center speaker.
•Switch the sound mode to DOLBY sound mode or DTS sound mode.
•This cannot be selected when using the headphones.
185
183
109
–
“Restorer” cannot be selected. •Check that an analog signal or PCM signal (Sample Rate=44.1/48 kHz) is input. For playback
of multichannel signals such as Dolby Digital or DTS surround, “Restorer” cannot be used.
•Switch the sound mode to other than “DIRECT” or “PURE DIRECT”.
154
110