User Guide Guía del usuario Guide d’utilisation Guida per l’uso Benutzerhandbuch Appendix English ( 2 – 5 ) Español ( 6 – 9 ) Français ( 10 – 13 ) Italiano ( 14 – 17 ) Deutsch ( 18 – 21 ) English ( 22 – 23 )
User Guide (English) Introduction The DN-312X is an ultra-slim 1U rack-mounted 12-channel mixer with 6 mic/line combination inputs and 6 additional line inputs. It has balanced XLR outputs, a 1/4” (6.35 mm) mono output that can be used to connect the DN-312X to a remote mixer, a pair of RCA stereo outputs that can be used to connect to a remote recording device, and 1/4” (6.35 mm) mic monitoring port that can be used to monitor the mics’ signals.
Features Front Panel 3 5 4 6 8 7 9 10 2 11 1 1. Power Switch: Use this switch to power DN-312X on or off. 2. Power Light: This light illuminates when DN-312X is powered on. 3. Mic In Level: Turn these knobs to set the input level of the corresponding mic/line inputs (Channels 1–6). 4. Stereo In Level: Turn these knobs to set the input level of the corresponding line inputs (Channels 7/8–11/12). 5. Signal (Sig) Lights: Indicates that the channel’s incoming audio signal is within an optimal range. 6.
Rear Panel 1 2 10 3 8 9 11 5 7 6 4 1. AC Power Input: Use the included power cable to connect this input to a power outlet. Alternatively, use the DC power input, described below. (If both power inputs are connected to power outlets, DN-312X will draw its power from the AC power input.) 2. Fuse Cover: If the fuse is broken, use a screwdriver or other tool to lift this tab, and replace the fuse with a fuse with the same rating. Using a fuse with an incorrect rating can damage the unit and/or fuse. 3.
Setup Items not listed under Introduction > Box Contents are sold separately. To set up DN-312X with your sound system: ® 1. If you are using any audio source with RCA outputs (Blu-ray players, stereos, etc.), use standard RCA cables to connect them to the line inputs on the rear panel. Your audio sources must be line-level (no phono-level turntables). 2. If you are using microphones or other audio sources that send a line-level signal, connect them to the mic/line inputs on the rear panel. 3.