Operation Manual

13
Getting started
Part names
and functions
Connections Control functionSetting Defaults
File and folder
settings
Playback Information
Connecting the external control
terminal
Parallel port
Connect an external device to the parallel port.
Parallel control can be used to control DN-700C from an external
device.
For details on parallel control, see “Parallel Control” (vpage54).
RS-232C terminal
Connect an RS-232C straight cable with a 9-pin D-sub connector to the
RS-232C serial terminal.
RS-232C control can be used for external control of the host device
and to configure settings.
For details on RS-232C control, see “RS-232C control” (vpage48).
Connecting headphones
Connect the headphones to the headphone jack (PHONES).
When you press the headphone volume adjustment knob (LEVEL), the
knob will spring out. After adjusting the volume, press the knob back
in again.
NOTE
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
Connecting the power cord
Insert the power cord when all other connections are completed.
Be sure to connect the ground wire also.
To the power socket
(AC100V,50/60Hz)
Japan models
Power cord
(provided)
NOTE
•Be sure to insert the power plug firmly into the AC outlet. If the plug
is not properly inserted, it could cause a malfunction or noise.
•Do not unplug the power cord while the unit is operating.
•Do not use a power cord other than the cord supplied with this unit.
To the power socket
(AC120V,60Hz)
U.S.A. and Canada models
To the power socket
(AC230V,50/60Hz)
European, UK and Asia/Pacific models