Operation Manual

Getting started Connections
Basic operations Advanced OperationsAdvanced operations TroubleshootingGlossary of termsInformation Specifications Index
42
Serial remote control function
CATEGORY CONTENTS COMMAND PARAMETER CODE REMARKS
POWER
POWER ON
PW
ON PWON<CR> Only enabled when Network standby is “Network On”.
STANDBY STANDBY PWSTANDBY<CR>
Input Source
Internet Radio
SI
InternetRadio SIIRADIO<CR>
Music Server MusicServer SISERVER<CR>
USB USB SIUSB<CR>
AnalogTuner(AM/FM) AnalogTuner(AM/FM) SITUNER<CR>
RHAPSODY RHAPSODY SIRHAPSODY<CR> Operation is only possible for U.S.A. and Canada models.
PANDORA PANDORA SIPANDORA<CR> Operation is only possible for U.S.A. and Canada models.
Favorite
FAVORITEdirectchangetoNo.** FV ** FV**<CR> **: Favorite No
“Cursor Up” Control
MN
CUP MNCUP<CR>
“Cursor Down” Control CDN MNCDN<CR>
“Cursor Left” Control CLT MNCLT<CR>
“Cursor Right” Control CRT MNCRT<CR>
“Enter” Control ENT MNENT<CR>
“FAVORITEON” FAVON MNFAVON<CR>
“FAVORITEOFF” FAVOFF MNFAVOFF<CR>
AnalogTuner(AM/FM)
TUNER Frequency UP
TF
ANUP TFANUP<CR>
TF COMMAND: '*' parameters can not operate when input
source isn’t tuner.
TUNER Frequency DOWN ANDOWN TFANDOWN<CR>
TUNER Frequency direct change AN****** TFAN*******<CR>
****.**kHzatAMband(>050000isAM.)(6digits)
*Only enabled when receiving AM broadcasts
****.**MHzatFMband(<050000isFM.)(6digits)
*Only enabled when receiving FM broadcasts
TUNER PRESET CHANNEL UP
TP
ANUP TPANUP<CR>
TP COMMAND: '*' parameters can not operate when input
source isn’t tuner.
TUNER PRESET CHANNEL DOWN ANDOWN TPANDOWN<CR>
TUNER PRESET direct change to No.** (PRESET No.) TPAN**<CR> **: Tuner preset No
TUNER PRESET MEMORY ANMEM** TPANMEM**<CR>
Band set to AM
TM
ANAM TMANAM<CR>
Band set to FM ANFM TMANFM<CR>
Return Tuning Mode Status ? TM?<CR>
Tuning mode set to AUTO mode ANAUTO TMANAUTO<CR>
Tuning mode set to MANUAL mode ANMANUAL TMANMANUAL<CR>
n Control command code table