Owner`s manual
5
Getting started ConnectionsConnections
Basic operations Advanced operations TroubleshootingExplanation termsInformation Specifications Index
ENGliSh
Connecting an antenna
•Connect the FM antenna or AM loop antenna supplied with the unit
to enjoy listening to radio broadcasts.
•After connecting the antenna and receiving a broadcast signal
(vpage 13 “Listening to FM/AM broadcasts”), fix the antenna
with tape in a position where the noise level becomes minimal.
•When listening to radio stations, always make analog connections
(vpage4 “Analog connections”).
w eq
AM loop antenna
(Supplied)
FM indoor antenna
(Supplied)
WhiteBlack
75 Ω coaxial
cable
FM outdoor
antenna
Direction of broadcasting station
AM outdoor
antenna
Ground
n AM loop antenna assembly
1
Put the stand section
through the bottom of the
loop antenna from the
rear and bend it forward.
Loop
antenna
Stand
Square
hole
Projecting
part
2
Insert the projecting part
into the square hole in the
stand.
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without
assembling.
Nail, tack, etc.
Standing alone
Use the procedure shown above to
assemble.
NOTE
•Do not connect two FM antennas simultaneously.
•Even if an external AM antenna is used, do not disconnect the AM
loop antenna.
•Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
•If the signal has noise interference, connect the ground terminal
(GND) to reduce noise.
•If you are unable to receive a good broadcast signal, we recommend
installing an outdoor antenna. For details, inquire at the retail store
where you purchased the unit.
1.DNP720AEE2_ENG_Final_0727.indd 5 2011/07/30 8:39:01