Owner`s manual

32
ENGliSh
Other functions
Button located on both the main unit and the remote control
BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control [BUTTON]
Symbols used to indicate buttons in this manual
[MODE]
[ENTER]
[CLEAR]
[9]
uio p
uio p
<1/3 ENTER><SOURCE>
Last function memory
This stores the settings as they were immediately before going into
the standby mode.
When the power is turned back on, the settings are restored to as
they were immediately before going into the standby mode.
Resetting the microprocessor
Perform this procedure if the display is abnormal or if operations
cannot be performed.
When the microprocessor is reset, all the settings are reset to their
default values.
1
Pull the power cord out of the power outlet.
2
Plug the power cord into a power outlet while pressing
<SOURCE> and <1/3 ENTER> simultaneously.
3
When the power indicator lights green, release the
buttons.
“Initialized” appears in the display.
If “Initialized” does not display in step 3, start over from step 1.
Using the cursor buttons
1
Display the screen for inputting characters .
2
Use o p to set the cursor to the character you want
to change.
3
Use ui to change the character.
•The types of characters that can be input are as shown below.
GLower case charactersH
abcdefghijklmnopqrstuvwxyz
G Upper case charactersH
ABCDEFGHIJKLMNOPQRSTUVWXYZ
GSymbolsH
! “ # $ % & ‘ ( )
z
+ , - . / : ; < = > ? @ [ \ ] ^ _ ` { | }
˜
GNumbersH
0123456789 (Space)
•The input character type can be switched by pressing
[MODE]
while the display name is being changed.
•Press [CLEAR] to delete the character.
•Press [9] to insert a space.
4
Repeat steps 2 and 3 to change the name then press
[ENTER] or <1/3 ENTER > to register it.
1.DNP720AEE2_ENG_Final_0727.indd 32 2011/07/30 8:39:26