8. SAFETY INSTRUCTIONS dread instructions All the safety and operating instructions should be read before the product fs operated. Ra stain Instructions The safety and operating ir should be retained for future reference. Heed Warnings ~ All warnings on the product and in the operating instructions shooed be ahead to. All operating and us instructions should instructions Follow Instructions be followed . Clanging ~ Unplug this product from the wall outlet before cleaning.
Thank you vary much for purchasing the DEMON fully automatic tur tabla system.
Ee + The drive belt is fitted under the platter. When assembling the layer, please handier the drive belt with care. + Ra move all packing materials stitched 10 the tone am, except they on the stylus, and then open the dust cover and assemble, Remove the stylus cover after assembling. Hold the platter by the holes at is outer surface, and then carefully lower the peatier so that the mincer 1 spindle enters the center bola.
RET] Before beginning = Tum off components. » To prevent damage to words, connect and disconnect by holding & Connect the power cord last. the plug, not the cord. « Contest everything cursorily. Louse connections can lead to + Make sure that you connect the white PIN-plug to the left (Distortion.
eu) cue 80 © Dust cover Dust cover hinge 4% rpm adapter and holder Equalizer amplifier switch Finger lever Size select lever STOP button + To stoop playback. START button « To start playback. Cartridge Tone arm rest « Holds the tans arm. Platter Spindle Huber mat SPEED button select ihe playback speed. BEET Before beginning = Turn on all the components. « Sot your amplifier's input selector to PHONON or AUX. + Remove the stylus cover before playback.
Open tha dust cover and place the record you wish to playback on the platter. Set the SPEED button according to the record 2 playback speed. © 33-14 rpm record © 45 pr too ot 033 BW G61 Set the selector fever so cording to the record size. Press the START button firmly for at lag 1 second. 4 | « The platter will start rotating, and playback wil start automatically. After the full record has bans played, the one arm will return to the tons arm rest and the platter stops rotating automatically.
SEI AE] ERE lee Wo power, Platter is not turning, « power cord is net connected properly. © connection. o ‘The drive bet is rot fitter to pulley. Check he dive belt sok the power cord He sound, w The output cords are not connected properly. Connect them securely to your amplifier's PHONON or AUX jacks. » The input selector ony your amplifier is not set to PHONED or AUX Bette PONG or AUX. Beseeching noise. Stylus turps. Distorted sound. « Dirty stylus or record.
PLACE STAMP HERE DEMON" ELECTRONICS, a Division of Deon Corporation (USA) P.O. Box 5370 Parsimony, NJ.
tn no ss rin ions pes AP r PSE ote pie DEMON' LIMITED WARRANTY This warranty will be honored only in the UA. Length of Warranty This warranty on your DEMON audio product which is distributed and warranted by DEMON TONICS, o Division of DEMON Incorporation remains iu effect for the following periods fro the date of the original consumer purchase from an AUTHORIZED TENON TROMBONES « Division of DEMON Corporation DEALER. Product Category Turntables £1) Autodidacts (DRL 4 yours (2} Fiat Automatic (20.
DENON® ELECTRONICS, a Division of DEMON Corporation Mailing address only: DEACON ELECTRONICS, PO. Box 5370 Parsimony, NL 07054-5370 DEMON i DEMON ELECTRONICS, DENOMINATE ELECTRONICS, 222 New Road 18878 Escritoire Corporate Dir, Suites, Parsimony, NJ.
