User Guide

Distorted sound from the HEOS HomeCinema

Solution Refer to Page

If the signal source is a volume-controlled output, turn it down a couple of steps from maximum. －

Check the signal source to be sure the distortion is not originating there. －

If HEOS HomeCinema’s volume is set to its maximum, turn it down a few steps. －

Trouble teaching HEOS HomeCinema remote control commands

Solution Refer to Page

Remember that while HEOS HomeCinema can learn almost all IR (infrared) remote commands, there remain a few rare code

formats that cannot be taught (much like some engineers we know).

–

Television speakers keep getting turned back up

Solution Refer to Page

Disable the television’s speakers (usually a setup-menu option, but a rear-panel switch on some televisions). If this is not possible,

the problem is likely that the television responds to press-and-hold (ramping) volume commands more quickly than the HEOS

HomeCinema; in this rare case use HEOS HomeCinema’s front-panel or supplied remote to turn the HEOS HomeCinema’s

volume up.

–

Contents Setup Use Troubleshooting Status LED Appendix