INTEGRATED AMPLIFIER PMA-A100 Owner’s Manual Manuel de l’Utilisateur Manual del usuario 1.PMAA100E3_ENG_003_0826.
ESPAÑOL FRANCAIS ENGLISH n SAFETY PRECAUTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
ENGLISH FRANCAIS ESPAÑOL n NOTE ON USE / OBSERVATIONS RELATIVES A L’UTILISATION / NOTAS SOBRE EL USO WARNINGS AVERTISSEMENTS ADVERTENCIAS • Avoid high temperatures. Allow for sufficient heat dispersion when installed in a rack. • Handle the power cord carefully. Hold the plug when unplugging the cord. • Keep the unit free from moisture, water, and dust. • Unplug the power cord when not using the unit for long periods of time. • Do not obstruct the ventilation holes.
ENGLISH Getting Started Preparations Prior to Playing·························································· 8 Starting Playback············································································· 8 Starting Recording·········································································· 8 Copying Recorders········································································· 9 Troubleshooting·································································9 Specifications··············
ENGLISH Getting Started Cautions on Handling • Before turning the power switch on Check once again that all connections are correct and that there are no problems with the connection cables. Connections Operation • Power is supplied to some of the circuitry even when the unit is set to the standby mode. When leaving home for long periods of time, be sure to unplug the power cord from the power outlet.
ENGLISH Getting Started Part Names and Functions Front Panel Q2 Q1 Connections Operation Q3 Q0 Troubleshooting t Indicates the status of the PMA-A100’s as follows: • For several seconds after the power is turned on················································ Red (blinking) • Power “ON”·············································Green • Muting········································ Red (blinking) • Standby······················································· Red • Power “OFF”················
ENGLISH Getting Started Part Names and Functions Rear Panel i Remote Control u For buttons not explained here, see the page indicated in parentheses ( ). y Connections Operation Amplifier operating buttons AMPLIFIER POWER button··························· (8) Troubleshooting CD player operating buttons Specifications q w e r Index q Input terminals (INPUTS) Connect your source equipment here.
ENGLISH Getting Started Connections NOTE Cautions on playing SA sources: When regular speakers not compatible with SA sources (DVD Audio discs, Super Audio CDs and other sources, including treble components above the audible range), set the properties of the player (DVD Audio player, Super Audio CD player, etc.) for use with regular speakers (or amplifiers). The speakers may be damaged if the volume is set too high when playing SA sources.
ENGLISH Getting Started Connecting the Speakers Connecting Players Speaker Connections If humming or other noise is generated when the ground wire is connected, disconnect it.
ENGLISH CD recorder / Tape deck 1 Getting Started Connecting Recorders CD recorder / Tape deck 2 AUDIO AUDIO IN L L L L L L R R R R R R L L L L L L R R R R R R Connections Operation AUDIO AUDIO IN AUDIO OUT AUDIO OUT Troubleshooting Specifications Connecting the Power Cord Wait until all connections have been completed before connecting the power cord. Index To household power outlet (AC 120 V, 60 Hz) Power cord (supplied) NOTE Insert the plugs securely.
ENGLISH Getting Started Operation Symbols used to indicate buttons in this manual Connections Operation Button·located·on·both·the·main·unit·and· the·remote·control· Button·only·on·the·main·unit·· POWER ···BUTTON ·
ENGLISH Copying Recorders Turn and select “RECORDER-1 1 2” (or “RECORDER-2 1 1”). [Selectable sources] RECORDER-1 1 2 RECORDER-2 1 1 Set the device connected to the RECORDER-1 (or RECORDER-2) terminal to the record mode. Start playback on the device connected to the RECORDER-2 (or RECORDER-1) terminal. NOTE The sound may be interrupted or noise may be recorded if INPUT SELECTOR is operated during recording.
ENGLISH Getting Started Specifications Index n Power amplifier section Connections Operation Rated Output Power: 2-channel driving (CD → SP OUT) 80 W + 80 W (8 Ω/ohms, 20 Hz ~ 20 kHz, T.H.D. 0.07 %) Dynamic power: 160 W + 160 W (4 Ω/ohms, DIN, 1 kHz, T.H.D. 0.7 %) High frequency distortion: 0.
www.denon.com D&M Holdings Inc. Printed in Japan 5411 10579 003D 4.PMAA100E3_BackPage__003.
