Owner's Manual
Table Of Contents
- Owner’s Manual
- Contents
- Accessories
- Part names and functions
- Connections
- Playback
- Turning the power on
- Switching the power to standby
- Selecting the input source
- Adjusting the volume
- Turning off the sound temporarily (Muting)
- Adjusting the tone and balance
- Switching the display’s brightness
- Playing CDs
- Connecting and playing back from a computer (USB-DAC)
- Connecting and playing back from a digital device (Coaxial/Optical 1/Optical 2/Optical 3)
- Recording
- Settings
- Tips
- Troubleshooting
- Power does not turn on / Power is turned off
- Operations cannot be performed through the remote control unit
- Display on this unit shows nothing
- No sound comes out
- Desired sound does not come out
- Sound is interrupted or noise occurs
- Music files on PC or Mac cannot be played back
- Audio from digital devices cannot be played back (Coaxial/Optical)
- The input source switches to “Optical 1”, “Optical 2”, “Optical 3” or “Coaxial”
- Appendix
o
Audio Device Settings (macOS only)
A
With the unit power off, connect the unit and Mac using a USB cable
(sold separately).
0
For the connection procedure, refer to the “Connecting a PC or Mac”
section. (v p. 20)
B
Press X.
C
Press INPUT SELECT to switch the input source to “USB-DAC”.
D
Move the cursor to “Go” on the computer screen, and then click
“Utilities”.
0
The utility list is displayed.
E
Double-click “Audio MIDI Setup”.
0
The “Audio Devices” window is displayed.
F
Check that “Use this device for sound output” is checked in “PMA-
A110”.
0
If a different device is checked, select and “Secondary click” on
“PMA-A110”, and then select “Use this device for sound output”.
.
⑥
PMA-A110
PMA-A110
Contents
Connections Playback Settings Tips Appendix
35
Front panel Rear panel
Remote control
unit
Index