Owner's Manual
Table Of Contents
- Owner’s Manual
- Contents
- Accessories
- Part names and functions
- Connections
- Playback
- Turning the power on
- Switching the power to standby
- Selecting the input source
- Adjusting the volume
- Turning off the sound temporarily (Muting)
- Adjusting the tone and balance
- Switching the display’s brightness
- Playing CDs
- Connecting and playing back from a computer (USB-DAC)
- Connecting and playing back from a digital device (Coaxial/Optical 1/Optical 2/Optical 3)
- Recording
- Settings
- Tips
- Troubleshooting
- Power does not turn on / Power is turned off
- Operations cannot be performed through the remote control unit
- Display on this unit shows nothing
- No sound comes out
- Desired sound does not come out
- Sound is interrupted or noise occurs
- Music files on PC or Mac cannot be played back
- Audio from digital devices cannot be played back (Coaxial/Optical)
- The input source switches to “Optical 1”, “Optical 2”, “Optical 3” or “Coaxial”
- Appendix
G
Select the “PMA-A110” format.
0
It is normally recommended to set the format to “384000.0 Hz” and
“2ch-32 bit Interger”.
.
⑦
PMA-A110
PMA-A110
H
Quit Audio MIDI Setup.
o
Playback
Install the desired player software on your computer beforehand.
Use the rear panel USB-DAC port to connect this unit to a computer.
(v p. 20)
1
Press INPUT SELECT to switch the input source to
“USB-DAC”.
Start playback on the computer’s player software.
0
If the sampling frequency cannot be detected, “Unlocked” will be
displayed.
0
“Unsupported” is displayed when audio signals that are not
supported by this unit are input.
Contents Connections Playback Settings Tips Appendix
36
Front panel Rear panel
Remote control
unit
Index