Owner's Manual
Table Of Contents
- Owner’s Manual
- Contents
- Accessories
- Part names and functions
- Connections
- Playback
- Turning the power on
- Switching the power to standby
- Selecting the input source
- Adjusting the volume
- Turning off the sound temporarily (Muting)
- Adjusting the tone and balance
- Switching the display’s brightness
- Playing CDs
- Connecting and playing back from a computer (USB-DAC)
- Connecting and playing back from a digital device (Coaxial/Optical 1/Optical 2/Optical 3)
- Recording
- Settings
- Tips
- Troubleshooting
- Power does not turn on / Power is turned off
- Operations cannot be performed through the remote control unit
- Display on this unit shows nothing
- No sound comes out
- Desired sound does not come out
- Sound is interrupted or noise occurs
- Music files on PC or Mac cannot be played back
- Audio from digital devices cannot be played back (Coaxial/Optical)
- The input source switches to “Optical 1”, “Optical 2”, “Optical 3” or “Coaxial”
- Appendix
Setting the TV Auto Play function
Set this when playing audio from a TV on this unit. When the TV is turned
on, this unit turns on and the input source is automatically switched to
“OPTICAL 1”, “OPTICAL 2”, “OPTICAL 3” or “COAXIAL” so that the audio
from the TV can be played through this unit. Set this according to the
connector on this unit where the TV is connected.
.
TV AUTO-PLAY
1
Press TV AUTO-PLAY to select the setting.
0
The setting changes each time TV AUTO-PLAY is pressed.
OPTICAL 1 / OPTICAL 2 / OPTICAL 3 / COAXIAL / Off
(Default: OPTICAL 1)
0
When the analog mode is set to “ANALOG MODE 1” or “ANALOG MODE 2”, the
TV Auto Play function does not work. (v p. 27)
0
Depending on your TV, the TV Auto Play function may not work.
0
This unit will not automatically turn off when the TV is turned off.
Contents Connections Playback Settings Tips Appendix
39
Front panel Rear panel
Remote control
unit
Index