Owner's Manual
Table Of Contents
- Owner’s Manual
- Contents
- Accessories
- Part names and functions
- Connections
- Playback
- Turning the power on
- Switching the power to standby
- Selecting the input source
- Adjusting the volume
- Turning off the sound temporarily (Muting)
- Adjusting the tone and balance
- Switching the display’s brightness
- Playing CDs
- Connecting and playing back from a computer (USB-DAC)
- Connecting and playing back from a digital device (Coaxial/Optical 1/Optical 2/Optical 3)
- Recording
- Settings
- Tips
- Troubleshooting
- Power does not turn on / Power is turned off
- Operations cannot be performed through the remote control unit
- Display on this unit shows nothing
- No sound comes out
- Desired sound does not come out
- Sound is interrupted or noise occurs
- Music files on PC or Mac cannot be played back
- Audio from digital devices cannot be played back (Coaxial/Optical)
- The input source switches to “Optical 1”, “Optical 2”, “Optical 3” or “Coaxial”
- Appendix
Setting the Auto Standby mode
You can set the unit to automatically switch to standby mode if the unit is
not operated for 30 minutes when there is no audio input (Auto Standby
mode).
Auto Standby mode is set to on by default.
.
AMPLIFIER
X
1
Press and hold AMPLIFIER X for 5 seconds or more to
switch it on and off.
The display changes as follows each time it is switched on and off.
0
When auto standby mode is on: “AutoStby On” is displayed.
0
When auto standby mode is off: “AutoStby Off” is displayed.
Contents
Connections Playback Settings Tips Appendix
40
Front panel Rear panel
Remote control
unit
Index