Owner's Manual
Table Of Contents
- Owner’s Manual
- Contents
- Accessories
- Part names and functions
- Connections
- Playback
- Turning the power on
- Switching the power to standby
- Selecting the input source
- Adjusting the volume
- Turning off the sound temporarily (Muting)
- Adjusting the tone and balance
- Switching the display’s brightness
- Playing CDs
- Connecting and playing back from a computer (USB-DAC)
- Connecting and playing back from a digital device (Coaxial/Optical 1/Optical 2/Optical 3)
- Recording
- Settings
- Tips
- Troubleshooting
- Power does not turn on / Power is turned off
- Operations cannot be performed through the remote control unit
- Display on this unit shows nothing
- No sound comes out
- Desired sound does not come out
- Sound is interrupted or noise occurs
- Music files on PC or Mac cannot be played back
- Audio from digital devices cannot be played back (Coaxial/Optical)
- The input source switches to “Optical 1”, “Optical 2”, “Optical 3” or “Coaxial”
- Appendix
Audio from digital devices cannot be played back (Coaxial/Optical)
“Unlocked” is displayed.
0
When digital audio signals cannot be detected properly, “Unlocked” is displayed. (v p. 37)
“Unsupported” is displayed.
0
“Unsupported” is displayed when audio signals that are not supported by this unit are input. Check the audio output signal format from your digital
device. (v p. 37)
The input source switches to “Optical 1”, “Optical 2”, “Optical 3” or “Coaxial”
The input source automatically switches to “Optical 1”, “Optical 2”, “Optical 3” or “Coaxial” when the TV connected to this unit is turned on.
0
Press the TV AUTO-PLAY button on the remote control unit to set the TV Auto Play function to “Off”. (v p. 39)
Contents
Connections Playback Settings Tips Appendix
49
Front panel Rear panel
Remote control
unit
Index