Protocol Specs

- 7 -
COMMAND and PARAMETER list
COMMAND CHANNEL PARAMETER
function example
PW 00 ON POWER ON/STANDBY change PW00ON<CR>
STANDBY PW00STANDBY<CR>
? Return PW Status PW00?<CR>
SV *01-12 UP CHANNEL VOLUME UP/DOWN , direct change to **dB SV01UP<CR>
DOWN SV01DOWN<CR>
** **:00 to 99 by ASCII , 90=0dB, 99=---(MIN) SV0180<CR>
? Return channel volume Status SV01?<CR>
SO 02-12(EVEN) NOR Operation mode NORMAL/BRIDGED change SO02NOR<CR>
BRI SO02BRI<CR>
? Return operation mode status SO02?<CR>
SF *01-12 OFF Channel Low Cut Filter OFF/ON change SF05OFF<CR>
ON SF05ON<CR>
? Return channel Low Cut Filter status SF05?<CR>
SI *01-12 BUSL Select input “BUS L” SI06BUSL<CR>
BUSR BUS R SI06BUSR<CR>
BUSM BUS MONO(L+R) SI06BUSM<CR>
AUX AUX SI06AUX<CR>
? Return channel Input status SI06?<CR>
ST 02-12(EVEN) CONT constant ST08CONT<CR>
TRIG Trigger in ST08TRIG<CR>
ASIG Audio signal ST08ASIG<CR>
OFF Off ST08OFF<CR>
? Return Zone Turn On status ST08?<CR>
00 PBTN Power button ST00PBTN<CR>
TRIG MASTER TRIGGER ST00TRIG<CR>
ONLI ON LINE ST00ONLI<CR>
? Return Power ON status ST00?<CR>
SV COMMAND : "*" parameter uses two or three ASCII characters. (see page6 D) section)
*01-12 : The ZONE that “Normal mode” was selected, odd and even CHANNEL selectable. If the ZONE that “BRIDGED mode” was
selected, only an even number CHANNEL selectable.