User's Guide


Setup
ENGLISH
Other Operations
NOTE
• When the “POWER CONFIGURATION” is set to “MASTER
TRIGGER”, the device will automatically enter the standby status
when no trigger input is detected for a period of 10 minutes.
• When the “POWER CONFIGURATION” is set to “ON LINE”, send
a standby command to the ETHERNET terminal or the RS-232C
terminal of the POA-3012CI.
• Power continues to be supplied to some of the circuitry even when
the power is in the standby mode. When leaving home for long
periods of time or when traveling, unplug the power cord from the
power outlet.
Check the Status of Each
Channel
1
Press the DISPLAY button.
b Zone status is indicated on the bottom line of the display.
b Turn the SELECT / ENTER knob to change the display as follows.
VOLUME CONTROL level
LOW CUT FILTER
Channel No. & INPUT Line
ZONE T.ON MODE
2
Press the DISPLAY button again.
b System status is indicated on the bottom line of the display.
b Turn the SELECT / ENTER knob to change the display as follows.
POWER CONFIG
DIMMER
n To Return to the Regular Display
Press the u / RETURN button until the display returns to normal.
Other Operations During Playback
n To Adjust the Volume
Refer to “VOLUME CONTROL” on the “Main Setup” menu
(vpage 13).
n To Reduce the Low Frequency Volume
Refer to “LOW CUT FILTER” on the “Main Setup” menu (vpage
13).
n To Switch Input Setting
Refer to “INPUT SELECT” on the “Main Setup” menu (vpage
13).
Operating the POA-3012CI Using a
Browser (Web control)
This function lets you operate the POA-3012CI using Internet
Explorer.
1
Check the POA-3012CI’s IP Address.
“Network Setup” – “Network Information” (vpage 14)
2
Input the POA-3012CI’s IP Address in Internet
Explorer.
For example, if the IP address is “10.3.18.90”, enter
http://10.3.18.90.
3
If the top menu is displayed, click “Setup Menu”.
4
When the “Setup Menu” is displayed, click on the
menu you want to operate.
Turning the Power On
Press the ON / STANDBY button.
The power indicator fl ashes green and the power turns on.
b The signal input to each channel is output from the speaker
terminal of each channel.
b The setting status of each channel is indicated on the display.
b Turn the SELECT/ENTER knob to change the channel displayed.
CH 1&2
BTL
BUS L+R
0.0dB
Output channel Input terminal
OPERATION MODE
(No display when in “NORMAL MODE”)
Volume level
n To return to STANDBY
Press the ON / STANDBY button again.
The power indicator lights red.
DISPLAYZONE 5
ON/STANDBY
SELECT/ENTER
u/ RETURN
ZONE operation mode indicators
Click
Setup
Click the menu
CHANNEL SETUP (vExample : 1)
SYSTEM SETUP (vExample : 2)
WARNING AND PROTECTION DATA
(vExample : 3)
AUDIO SIGNAL AND TRIGGER
INPUT (vExample : 4)
OPTION SETUP (vExample : 5)
Click “SAVE” when you want to save settings,
and click “LOAD” when you want to call settings.
Becomes each operation screen.
Operations
Getting Started Connections Troubleshooting Specifi cationsOperations
1.POA-3012CI_ENG_101.indd 17 2008/07/30 14:08:30