User's Manual


Getting Started Connections Operations
Troubleshooting
ENGLISH
Specifications
[Selectable Channels]
[Selectable items]
CONSTANT
: The power amplifier operates constantly.
TRIG. IN
: The power amplifier operates when trigger input is
detected.
When trigger input is not detected, it remains in
standby mode.
A.SIGNAL
: The power amplifier operates when an audio signal is
input.
If no input is received for a period of 10 minutes, it
switches to standby mode.
OFF
: Turns the power amplifier off.
The POA-3012CI accepts +3 ~ 30V trigger input.
h
DIMMER MODE
Adjust display brightness of the POA-3012CI.
[Selectable items]
Bright
: Normal display brightness.
Dim
: Reduced display brightness.
Dark
: Very low display brightness.
When setting to “Dim”, “Dark” and “OFF”, the display brightness
changes to “Bright” for about 3 seconds during the operation before
reverting to the set brightness.
[Selectable items]
POWER BUTTON
: Operate with the ON/STANDBY button only.
ON LINE
: Operate from an external device via Ethernet
or RS-232C input.
MASTER TRIGGER
: Operate by detection of a trigger signal input to
the MASTER TRIGGER input terminal.
• Turns on when a signal is detected.
• If no input is received for a period of 10
minutes, it switches to standby mode.
g
ZONE TRIGGER ON MODE
Sets the operating specifications for the power amplifiers
of each ZONE.
For details of the channels which can be set in each mode, see
GSelectable ChannelsH in “f OPERATION MODE” (vpage 13).
j
POWER CONFIGURATION
Select the method for turning on the POA-3012CI.
• The POA-3012CI accepts +3 ~ 30 V trigger input.
• Even when “ON LINE” or “MASTER TRIGGER” has been set, power
source operation is possible by means of ON / STANDBY button.
Setup
OFF
: Display is off unless controls are operated.
Network Setup
Make network settings.
F Menu tree F
Main Setup
Network Setup
a Network Information
s Network Setup
a
Network Information
Display network information.
[Items to be checked] DHCP= ON or OFF IP Address
MAC Address
• If you are using a broadband router (DHCP function), there is no need
to make the settings at “Setting the IP Address” and “Setting the
Proxy”, since the DHCP function is set to “ON” in the POA-3012CI’s
default settings.
• If the POA-3012CI is being used connected to a network without the
DHCP function, the network settings must be made. In this case,
some knowledge of networks is required. For details, consult a
network administrator.
• If you cannot connect to the Internet, recheck the connections and
settings (vpage 8).
• If you do not understand about Internet connection, contact your ISP
(Internet Service Provider) or the store from which you purchased
your computer.
• DHCP (Dynamic Host Configuration Protocol) :
These are systems by which the IP address and other network
settings are automatically set for the POA-3012CI, computer,
broadband router and network devices.
• DNS (Domain Name System) :
This is a system for converting the domain names used when
browsing Internet sites (for example, “www.denon.jp”) into the
IP addresses actually used for communications (for example,
“202.221.192.106”).
1.POA-3012CI_ENG_101.indd 14 2008/07/30 14:08:26