USER MANUAL Dension BTA1500 Bluetooth Module DEBTA-9201-2 1 www.dension.
USER MANUAL - BTA1500 Contents 1. Introduction .......................................................................................... p.2 2. Useful Information ................................................................................ p.2 3. Package contents ................................................................................... p.3 4. Car compatibility ................................................................................... p.3 5. Basic installation ...............
call, the music will continue. Some mobile phone models will restart the song from the beginning. • If a phone is connected to the system as a handsfree device, the other phone can connect only as an A2DP source. In this case, the device which is playing music can be used as a phone but without the handsfree function. Some phones give you the option to choose the connection type.
*DWHZD\ *DWHZD\ Gateway 500 iPod iPod BTA 1500 %7$ %7$ DP1 iPod Mic Miic DP2 BTA R 5DGLR adio Microphone Microphone 1. Make sure the phone module functionality is enabled on the car and remove any preinstalled phone module 2. Connect the iPod dock cable to device port 1 (DP1) on the Gateway 500 (if you are using the BTA1000, you’ll need to disconnect it from device port 1 first) 3. Download the latest Gateway 500 firmware (FW) from www.dension.com 4.
Before using your Bluetooth hands free functions, you need to pair your phone to the BTA 1500. This only needs to be done once after installation. 6. Pairing 6.1. Porsche 1. If it is needed, enable the factory Bluetooth module with a diagnostic computer. 2. Every time you turn on the system, the following warning message will be displayed: ‘System error: Phone not available.’ Press ‘Confirm’. You can now proceed. 3. At first startup the Bluetooth handsfree communication will be turned off.
5. After successful connection, the phone’s name will appear on the car audio system display. It is now ready to use via the car audio system 6.3. Audi The BTA1500 module fitted in AUDI car models can give you a limited set of functions compared to the factory fitted module. In order to carry out the pairing process do the following: 1. Choose the CDC menu and‘Disc 6’ on the Audi car audio system, then enter the ‘>Source’ folder 2. Choose ‘BT Audio’ and select the pairing item.
BT Audio playback from A2DP/AVRCP source. BTA1500 supports Advanced Audio Distribution Profile (A2DP) / Audio/Video Remote Control Profile (AVRCP) for audio playback. Due to limitations of these standards no song information is provided by the Bluetooth device and only Next/Back/Pause/Play functions are available from the car radio or the steering wheel. Using the ‘BT Audio’ function 1. After you have paired successfully, select ‘BT Audio’ from the ‘Source’ menu option.