User Manual

SETTING THE SYSTEM
You can set the theft deterrent system with or without the radar sensor function. To
cancel the radar sensor function, do step 3. To turn on the radar sensor function, skip
step 3.
1. Turn the ignition key to the “LOCK” position and remove it.
2. Have all passengers get out of the vehicle.
3. To cancel the radar sensor function – Push the “SENSOR OFF” switch in the map
lamp base.
4. Close all the side doors, hood and back door/trunk lid securely.
5. Push the “LOCK” switch of the wireless remote control key. At this time, the turn
signal lights flash once and the indicator light comes on.
However, if the “LOCK” switch is pressed when any of the side doors, back door/trunk
lid or hood is opened, the setting is interrupted until all the side doors, back door and
hood are closed.
The system will automatically be set after 30 seconds. When the system is set, the
indicator light will start flashing.
After the alarm stops, the indicator light will start flashing.
Reactivating the alarm
Once the system has been set, even if the alarm has been stopped, the system will
continue to be activated under conditions described in “ACTIVATING THE SYSTEM”.
The alarm can sound again and activation can occur again up to ten times.
Stopping the alarm
To stop the alarm, push the “UNLOCK” switch of the wireless remote control key. At
this time, the system will be canceled. The alarm may sound if the battery is recharged
or replaced. If this happens, stop the alarm using the method described above.